What is the torque on the 2018 Honda lug nuts?

The typical lug-nut torque for most 2018 Honda models is 80 ft-lbs (108 Nm), though the exact specification can vary depending on the model and wheel configuration.

Torque specs come from the vehicle manufacturer and can differ by model year, trim, wheel size, and whether aftermarket wheels are installed. For 2018 Hondas, 80 ft-lbs (108 Nm) is the common target, but it’s essential to verify the exact figure for your specific model and wheel setup in the owner's manual or the official service manual. Using an incorrect torque can lead to uneven clamping, rotor warping, or wheel failure, so confirmation is important.

Model- and wheel-related guidance

While 80 ft-lbs (108 Nm) is widely used across many 2018 Honda models, some configurations or aftermarket wheels may have different requirements. Always confirm with documented specifications for your exact vehicle type.

Why 80 ft-lbs is commonly used

This target provides a balance between adequate clamping force to secure the wheel and minimizing risk of thread damage on Honda’s standard wheel studs. It is a practical default for many passenger models in the 2018 lineup, including popular models like Civic, Accord, CR-V, HR-V, and others, but individual variants can differ slightly.

How to verify and apply torque correctly

To ensure accuracy, consult the owner’s manual or the official Honda service manual for your exact model and wheel size. If you don’t have the manual handy, contact a Honda dealership or certified technician to confirm the torque specification for your configuration. When tightening:

• Use a calibrated torque wrench set to the manufacturer’s torque value (commonly 80 ft-lbs / 108 Nm for many 2018 Hondas).


• Tighten lug nuts in a star or criss-cross pattern to ensure even loading.


• Do not rely on an impact wrench to achieve final torque; tighten with a torque wrench to the specified value.


• After replacing wheels, recheck torque after a short drive (often 50–100 miles) to account for seating of the threads and wheel.


• Avoid applying anti-seize lubricants on wheel studs unless explicitly recommended by Honda for a particular wheel setup.

For any 2018 Honda with unique wheels, after-market rims, or different tire sizes, the precise torque may differ. When in doubt, verify through official documentation or a dealership to prevent installation issues.

Summary

In most cases, the lug nuts on 2018 Honda vehicles should be tightened to about 80 ft-lbs (108 Nm). Always confirm the exact specification for your specific model and wheel configuration in the owner’s manual or service manual, and follow proper tightening procedures to ensure safety and proper wheel seating. If you’re unsure, consult a Honda professional to obtain the correct torque for your vehicle.

What size are the lug nuts on a Honda CRV 2018?

If you own a Honda CR-V, you've likely needed to change a tire or remove the wheels at some point. And to do that, you need the right socket size to remove the Honda CRV lug nuts. So what size socket do you need? For all factory 1997-2025 Honda CR-V wheels, the socket size is 19mm and the lug nut size are M12 x 1.5.

What is the torque on the 2018 Honda Accord wheel lugs?

The wheel nut torque is 80 lb·ft (108 N·m). This kit should be installed only if the ambient air temperature is 60°F (15°C) or above. To allow the tire and loading information label adhesive to cure, do not wash the vehicle for 24 hours.
PDF

What is the torque on Honda lug nuts?

Tighten the lug nuts securely. The recommended torque is: 110 N·m (11 kg-m,80 Ib-ft) If a torque wrench was not used, ask an authorized Honda dealer to verify the torque as soon as possible.

What is the torque spec on a 2018 Honda Civic?

2018 Honda Civic 4D Specifications