The 2013 Nissan Rogue with the common 2.5-liter four-cylinder engine requires about 4.8 quarts (roughly 4.5 liters) of engine oil with a filter when performing an oil change. This article explains the official capacity, the engine it applies to, and practical maintenance guidance.
Engine and capacity basics
The 2013 Rogue sold in North America largely uses the QR25DE 2.5-liter engine. Knowing the correct oil capacity for this engine helps ensure you replace and top up oil accurately after an change.
What engine powers the 2013 Rogue?
Most 2013 Rogue models use the 2.5L inline-four (QR25DE) with a CVT. The official oil capacity for this configuration is 4.8 quarts (about 4.5 liters) with a filter. Always verify your exact engine code if you’re unsure.
Oil capacity and fill guidance
The capacity figure above applies to a standard oil change with the filter replacement, using conventional or synthetic oil that meets Nissan specifications.
Key facts about the oil capacity for the 2013 Rogue's 2.5L engine:
- Engine: 2.5L inline-4 (QR25DE).
- Oil capacity with filter: 4.8 quarts (approximately 4.5 liters).
- Recommended oil viscosity: SAE 5W-30 (Nissan-approved API service standard).
- Filling guidance: After an oil change, fill gradually and check the dipstick to bring the level to the FULL mark.
In practice, use the correct filter and oil grade, then recheck the level after the engine reaches normal operating temperature. Do not overfill, as excess oil can cause engine problems and emissions issues.
Oil type and maintenance tips
Current guidance for the 2.5L engine generally supports using synthetic or synthetic-blend 5W-30 oil that meets API SN or newer standards. Follow Nissan’s maintenance schedule and consider synthetic oil for severe driving conditions, frequent short trips, or extreme temperatures.
Checking and maintaining the correct oil level
Properly checking the oil level prevents underfill or overfill. The steps below outline how to verify the level after an oil change or during routine maintenance.
- Park on level ground and let the engine cool for several minutes after turning it off, for an accurate reading.
- Pull the dipstick, wipe it clean, reinsert fully, then pull it again to read the level.
- Ensure the level sits between the MIN and MAX marks; if low, add small amounts of oil and recheck.
- Avoid exceeding the MAX mark, as overfilling can lead to engine damage.
Following these steps helps ensure proper lubrication and engine performance. Adhere to the factory maintenance schedule for oil changes to maximize engine life.
Summary
The 2013 Nissan Rogue’s standard 2.5L engine requires about 4.8 quarts (approximately 4.5 liters) of engine oil with a filter, typically using SAE 5W-30 oil. Verify your exact engine variant if needed, use the correct oil grade, and check the dipstick after filling to ensure the level is at the FULL mark. Regular maintenance aligned with Nissan’s guidance will help keep the Rogue running smoothly.