The lug nuts on a 2016 Ford Escape are M12 x 1.5 with a 21 mm hex head (about 13/16 inch) and use a 60-degree conical seat.
These specs cover the typical factory wheel setup for that model year. Variations can occur if aftermarket wheels or non-standard hardware are installed, so it’s wise to confirm by checking the owner’s manual, the tire and wheel placard on the driver’s door jamb, or by inspecting the actual lug nuts on your wheels.
Lug nut specifications
Before listing the core facts, note that the following details apply to typical 2016 Escape factory hardware and are the most common values when shopping for replacement lug nuts or a socket size.
- Thread size: M12 x 1.5
- Seat type: 60-degree conical (tapered) seat
- Hex size (across flats): 21 mm (approximately 13/16 in)
- Number of lug nuts per wheel: 5
- Recommended torque: 100 ft-lb (135 Nm)
When replacing hardware, ensure you use the correct seat type and thread pitch to avoid damage or improper seating.
Notes and verification
Because wheel configurations can vary by trim, wheel package, or aftermarket replacements, you should confirm the exact lug nut size for your specific vehicle model and wheel combination. The door jamb placard and the owner’s manual are the most reliable sources. If you recently changed wheels or tires, re-check the nuts after the first 50-100 miles of driving.
Summary
For a 2016 Ford Escape with factory wheels, expect lug nuts in M12 x 1.5 size with a 21 mm hex, a 60-degree conical seat, and a torque of about 100 ft-lb (135 Nm). Always verify with official sources when in doubt and re-tighten after initial mileage to ensure safe wheel mounting.