Basic answer: On most Honda CR‑V models, turn on the rear wiper with the end of the right-side stalk—set it to ON for continuous wipe or to INT for intermittent wipe, and pull the stalk toward you to spray washer fluid.
Step-by-step: turning on the rear wiper
Here are the practical steps to operate the rear wiper and washer on a typical CR‑V cockpit layout.
- Locate the wiper stalk on the right side of the steering column.
- Turn the end of the stalk to ON for a continuous wipe, or to INT for intermittent wiping.
- To spray washer fluid, pull the end of the stalk toward you briefly; the rear wiper will wipe after spraying.
- Return the end of the stalk to OFF when you’re done, or leave it in INT/ON if you want ongoing wiping.
These controls are standard on most CR‑V models; the exact markings may vary slightly by year or trim, but the function remains essentially the same.
Variations by model year
Most CR‑V generations share a similar rear wiper control on the end of the stalk, but some labels or the number of wipe cycles can vary by year or trim.
- Older CR‑V generations commonly use a three-position end-stalk switch: OFF, INT, and ON.
- From around 2017 onward, CR‑V models typically use the same end-stalk control with INT and ON; washer spray is activated by pulling the stalk toward you, triggering a wipe cycle after spraying.
- On certain hybrid or special trims, the rear wiper control remains the same; differences are mostly cosmetic or related to front wiper setup.
Check your owner’s manual for the exact rear wiper control for your year and trim if you’re unsure.
Maintenance and tips
Keep the rear wiper working well with these quick checks and tips.
- Inspect the rear wiper blade for wear or streaking and replace if necessary.
- Ensure the washer fluid reservoir is filled with appropriate fluid for your climate.
- If the wiper seems sluggish or stutters, inspect the linkage and motor under the rear hatch area or consult a technician if you hear unusual noises.
Following these practices will help ensure the rear wiper functions reliably when you need it.
Summary
To turn on the rear wiper on a Honda CR‑V, use the end of the right-hand wiper stalk: rotate to ON for continuous wipe, or to INT for intermittent wipe, and pull the stalk toward you to spray washer fluid. Exact labels and positions can vary slightly across generations, so refer to your owner’s manual for the precise procedure for your year and trim.