The starter in a 2016 Honda Accord Sport sits on the passenger side of the engine, bolted to the bell housing where the transmission attaches, and is generally accessible from underneath the vehicle with the front undertray removed.
This article explains the exact location, how to identify it, and what to expect when inspecting or replacing the starter on the Accord Sport. While the exact appearance can vary slightly by model year and transmission, the overall layout remains consistent for the 2.4-liter Earth Dreams engine family used in the 2016 Accord.
Where to look for the starter
These cues help you pinpoint the starter’s position in the engine bay and understand what you’re looking at when you inspect or replace it.
- Location on the engine: mounted to the engine block on the passenger side, at the bell housing where the transmission attaches.
- General position: toward the front-right side of the engine bay when viewed from the front of the car, and near the bottom portion of the engine close to the exhaust area.
- Accessibility: typically accessible from underneath the vehicle after removing the front undertray or splash shield; you may need to raise the car safely for access.
- Electrical connections: connected to a large battery cable (positive) and a smaller ignition/solenoid trigger wire; you’ll usually see two main leads and two mounting bolts.
Recognizing these cues will help you confirm you’re looking at the starter rather than another nearby component during inspection or replacement.
Accessing and handling the starter: quick guidance
If you are planning to inspect or replace the starter, follow these general steps to locate and prepare without causing damage. This section is informational and not a substitute for a full service manual.
- Park on a level surface, engage the parking brake, and disconnect the negative battery terminal to prevent shock or arcing.
- Raise the front of the car and support it securely with jack stands; remove the front undertray or splash shield if equipped to expose the bottom area of the engine bay.
- Identify the starter on the passenger side of the engine, bolted to the bell housing of the transmission; note the two mounting bolts and the electrical connections.
- Carefully loosen and remove the mounting bolts, detach the electrical connectors, and remove the starter from the engine assembly.
With the starter removed, you can compare it to a replacement unit to ensure compatibility and proceed with installation following reverse steps and proper torque specifications.
Summary
In the 2016 Honda Accord Sport, the starter is mounted to the engine block on the passenger side, attached to the bell housing of the transmission. It is generally accessed from underneath the vehicle with the front undertray removed. Always disconnect the battery and follow safety protocols when inspecting or replacing the starter.