Where is the oil filter on my 2016 Nissan Altima?

On a 2016 Nissan Altima, the oil filter is a spin-on canister mounted on the engine block on the passenger side, near the oil pan, and is accessible from underneath with the front end raised.

Engine options and typical filter location

The 2016 Altima primarily uses a 2.5-liter four-cylinder engine in most trims. The following guidance describes the filter location you’re likely to encounter on that engine. If your car has a different configuration, check the owner’s manual or service manual for the exact location.

2.5L four-cylinder (QR25DE) — location

The oil filter on the 2.5L QR25DE is located on the passenger side of the engine block, just above the oil pan. Access is easier from underneath the car, after removing the front undercarriage splash shield or mud guard.

Before you begin the removal process, ensure the vehicle is safely raised and supported on jack stands, and that the engine is cool.

• Safely raise the car and support it with jack stands.


• Remove the front undercarriage splash shield (or mud guard) to expose the lower side of the engine.


• Look for a cylindrical canister-shaped oil filter mounted to the engine block on the passenger side, near the oil pan.


• Using a filter wrench, loosen the filter by turning it counterclockwise. Have a drain pan ready for any oil that spills.


• Remove the filter, wipe the mounting surface, install the new filter by hand until snug, then give it a final 3/4 turn (do not over-tighten).


• Reinstall the splash shield and lower the car. Refill the engine with the correct amount of oil and check for leaks.

After replacing the filter, always check for leaks and oil level with the dipstick after running the engine briefly.

Other engine configurations

If your Altima uses a different engine configuration, the filter will still be mounted near the engine, typically on the side of the block or near the oil pan. For the exact location, consult the owner’s manual or a Nissan service manual for your specific VIN and trim.

How to verify the exact location on your car

To confirm precisely where the oil filter sits on your 2016 Altima, you can:

• Check the owner’s manual for maintenance sections and diagrams.


• Inspect under the hood at the engine block and trace from the oil pan area; the filter is a cylindrical canister with a threaded end that accepts a filter wrench.


• Refer to a VIN-specific repair guide or service database for a photo and exact placement for your vehicle.

When in doubt, consult a professional mechanic or Nissan dealer for location confirmation before attempting a filter change.

Summary

For most 2016 Nissan Altimas equipped with the common 2.5L four-cylinder engine, the oil filter is on the passenger side of the engine block near the oil pan and is accessible from beneath after removing the front undercarriage shield. If your vehicle uses a different engine configuration, the filter will still be mounted to the engine block in a nearby area, but exact placement can vary. Always verify with the owner’s manual or service guide and follow safe procedures when performing an oil change.

How to change the oil filter on a 2016 Nissan Altima?

Make sure the old gasket is removed along with the filter. Installing a new oil filter apply a small amount of oil to the rubber gasket on the new oil filter. And then screw it onto the engine.

Where is the oil filter located in a 2016 Nissan Altima?

You can order the parts and products used in the video on carparts.com via the link in the description. Take the new filter lightly coat the seal with oil on the screwed.

Where is the oil filter on a Nissan Altima?

While the oil drains, you can access the oil filter in the passenger fender well by removing the push clips on the panel covering it, and moving the panel aside. Position shop towels or rags below the filter before you unscrew it.

What's the fastest Altima?

2021 Altima Engine Performance