The typical oil capacity for the 3.5-liter V6 in the 2009 Honda Accord is 5.5 quarts with a new filter. If you don’t replace the filter, you’ll need about 5.0 quarts. Always confirm with your owner’s manual and check the dipstick after filling.
In more detail, the 2009 Accord’s V6 uses a 3.5L engine, and the official service capacity is commonly cited as 5.5 quarts when performing a full oil change with a new filter. Actual requirements can vary slightly based on whether the filter is replaced, the presence of any aftermarket parts, and the exact trim or engine variant. For the most accurate result, consult the vehicle’s owner manual and verify the oil level with the dipstick after adding oil.
Official capacity and practical guidance
To provide a quick reference, here are the typical quantities you should have on hand when changing the oil on a 2009 Accord V6.
- 5.5 quarts with a new filter
- 5.0 quarts if you do not replace the filter
Note that minor variance can occur due to differences in filters, sump capacity, or if a dealer has performed prior maintenance with different components. Always fill gradually and recheck with the dipstick to reach the full mark.
Recommended oil and viscosity
The 2009 Accord V6 generally uses a light engine oil with a viscosity recommended by Honda (usually 5W-20, with some climates allowing 5W-30). Use oil that meets Honda’s specifications and the API rating cited in your manual. If in doubt, follow the exact specification listed for your vehicle’s trim and region.
Viscosity guidelines
In typical climates, 5W-20 is a common recommendation for modern Honda V6 engines, while 5W-30 may be advised in hotter or more demanding conditions. Always confirm the exact viscosity in your owner’s manual or by contacting a Honda service representative.
Confirming the exact capacity for your car
If you want to be precise for your specific vehicle, you can follow these steps:
- Consult the official owner’s manual for your exact trim and engine code (the 2009 Accord V6 uses a 3.5L engine).
- Check for any service bulletins or dealer notes that might adjust capacity due to a redesigned sump or filter changes.
- During an oil change, start by adding 5.5 quarts, then check the dipstick and top off in small increments if needed.
- Run the engine briefly, recheck the level, and ensure it sits at the full mark on the dipstick after the oil has settled.
Following these steps will help you determine the exact amount needed for your individual vehicle condition.
Summary
For a 2009 Honda Accord with the 3.5L V6, plan to use about 5.5 quarts of oil with a new filter (5.0 quarts if you’re not replacing the filter). Always verify with the owner’s manual and confirm the level using the dipstick after filling. If in doubt, consult a trusted mechanic or Honda dealer to confirm the exact capacity for your car’s configuration.
What kind of oil does a 3.6 L V6 take?
Jeep Wrangler Oil Type by Year & Engine — Complete Chart
| Engine | Model Years | Recommended Oil |
|---|---|---|
| 3.6L Pentastar V6 | 2012–2018 | SAE 5W-20 Full Synthetic |
| 3.6L Pentastar V6 | 2007–2011 | SAE 5W-20 Conventional or Synthetic |
| 3.0L EcoDiesel V6 | 2020–2026 | SAE 5W-40 Full Synthetic Diesel |
| 3.8L V6 | 2007–2011 | SAE 5W-20 Conventional or Synthetic |
How much oil for a 2009 Honda Accord V6?
Oil Grade: API*
| Viscosity: | 5W-20 (All TEMPS) |
|---|---|
| Capacity: | 4.2 quarts. w/of. After refill check oil level. |
| Capacity: | 4.5 quarts (with filter). After refill check oil level. |
| Torque: | 29 ft/lbs (Oil Drain Plug) |
What year is the fastest V6 accord?
2004
The fastest Honda Accord ever was a 2004 V6 model, which delivered a 0-60 mph time of just 5.9 seconds.
What is the weakness of the Honda Accord?
This powertrain shines in sport and touring trims providing a balance of power and smoothness that rivals European sedans hybrids with their 2.0 L Atkinson cycle engine and ECVT excel in fuel economy.