Yes. You can reset the Honda Pilot maintenance light (Maintenance Minder) by turning the ignition to ON (engine off) and using the instrument panel's SELECT/RESET control to reset the Oil Life to 100% after you’ve completed the scheduled maintenance.
What the Maintenance Minder is and when the light appears
The Maintenance Minder estimates when service is due based on driving conditions and engine data. The light or message often shows as MAINT or a percentage for Oil Life. If you see a Check Engine Light (CEL) instead, that is a different warning and requires diagnosis rather than a simple reset.
Resetting the Maintenance Minder on a Honda Pilot (typical steps)
Use the following steps to reset the Oil Life and the maintenance reminder on most Honda Pilot models after the scheduled service.
- Turn the ignition to ON (II) with the engine off. Do not start the engine.
- On the instrument panel display, rotate the SELECT/RESET knob or use the appropriate control to highlight Oil Life within the Maintenance Minder screen.
- Press and hold the SELECT/RESET knob until the Oil Life percentage begins to blink, then release.
- Press and hold again until Oil Life resets to 100% and the display stops blinking.
- Turn the ignition OFF, then start the engine to verify that the Oil Life reads 100% or the display returns to its normal state.
Note: Some trims or model years may use slightly different controls (such as a dedicated MAINT/RESET button or a left stalk). If you can't locate Oil Life or the Reset option, consult your owner's manual for the exact steps for your year and trim.
Variations by year and interface
Most Honda Pilot models from the mid-2010s through the current generation share the Maintenance Minder concept, but button names and on-screen prompts can vary by year and trim. If your vehicle uses a different control scheme, follow the on-screen prompts in the Maintenance Minder section to locate Oil Life and perform the reset. For very old trims, the process may differ, so checking the manual is advisable.
When not to reset
If the light is the Check Engine Light or another warning related to the engine or emissions, resetting will not fix the underlying issue. Address any diagnostic codes or service needs with proper testing and, if necessary, service from a Honda dealer or qualified mechanic.
Summary
Resetting the Honda Pilot Maintenance Minder is a straightforward procedure after you’ve completed scheduled maintenance. Navigate to the Oil Life on the Maintenance Minder screen, reset it to 100%, and verify on the next engine start. If the light reappears or you’re unsure of the steps for your exact year and trim, refer to the owner’s manual or contact a Honda dealer for guidance.