Power steering fluid location on a Chrysler 200 depends on the model year. Models from 2015 onward use electric power steering and have no reservoir to service, while 2011–2014 models with hydraulic steering do have a dedicated power steering fluid reservoir located in the engine bay on the driver’s side near the pump.
System configurations by model year
Two main configurations determine whether a fluid reservoir exists and where to look. Understanding which system your car has will guide you to the right location and steps.
- 2011–2014: Hydraulic power steering. The reservoir is in the engine bay on the driver’s side, near the power steering pump, and uses Mopar ATF+4 fluid.
- 2015–2017: Electric power steering (EPAS). There is no traditional power steering fluid reservoir to check or top up.
Knowing the difference helps you avoid chasing a non-existent reservoir on newer cars and focuses you on the correct maintenance steps for older, hydraulically steered vehicles.
Hydraulic power steering: locating the reservoir (2011–2014 models)
For drivers of older Chrysler 200s with hydraulic steering, follow these steps to locate and assess the power steering reservoir. This helps you check fluid levels and top up if necessary without fumbling around the engine bay.
- Park on level ground, engage the parking brake, and open the hood with the engine cool.
- Standing in front of the vehicle, look to the driver’s side of the engine bay for the power steering pump and its reservoir. The reservoir is typically near the front-left corner of the engine compartment.
- Identify the cap or a dipstick on the reservoir, which is usually labeled Power Steering Fluid or shows a steering wheel icon.
- Check the level against the marked Min/Max or cold/hot indicators on the reservoir. If low, fill with Mopar ATF+4 until the proper level is reached.
- Beat any bulging or leaking hoses; after topping up, replace the cap securely and run the engine briefly with the steering wheel turned from lock to lock to circulate the fluid, then recheck for leaks.
Keep in mind that overfilling can cause foaming and leaks. If you notice persistent leaks, whining noises, stiff steering, or a warning light, seek service promptly.
Electric power steering: what to know (2015–2017 models)
On Chrysler 200 models equipped with electric power steering, there is no reservoir to service. The system uses a motorized steering assist integrated into the steering column and controlled by the vehicle’s electronic control unit. Maintenance tasks are typically limited to diagnostics, software updates, and steering column servicing performed by a dealer or qualified technician.
If you experience steering issues on a later model year, the problem is unlikely to be fluid-related and will require professional diagnostics to check for electrical faults, sensors, or the EPS controller.
How to verify which system your car has
To confirm whether your Chrysler 200 uses hydraulic or electric power steering, inspect the engine bay and look for the reservoir. If you see a labeled power steering fluid reservoir, you have hydraulic PS. If there is no reservoir in sight, your model uses EPAS. When in doubt, consult the owner’s manual or contact a dealer with your VIN for an exact specification.
Summary
In short, the Chrysler 200’s power steering fluid location depends on the model year. Hydraulic versions (2011–2014) have a reservoir on the driver’s side of the engine bay near the pump that takes Mopar ATF+4. Electric Power Steering versions (2015–2017) do not have a fluid reservoir, and steering issues require electronic diagnostics rather than fluid checks. Always verify your specific configuration by checking the engine bay or referring to the owner’s manual or VIN-based documentation.
Does a Chrysler 200 have power steering fluid?
Light. Below the minimum. Line or even lower than that or in the middle. Here. It's good idea to have it up to the top fill.
Where is the power steering fluid located on a 2015 Chrysler 200?
The power steering fluid cap on a 2015 Chrysler 200 is located on the power steering fluid reservoir, typically near the engine bay's front or side.
Where to put power steering fluid on a Chrysler?
Line And then the minimum fill line is just above that crease in the bottle. Right. There. I will have power steering fluid linked down in the description. Below where you can get it on Amazon.
How do I reset my electric power steering?
5 seconds. Turn the steering wheel to the full left lock position and apply force for approximately. 5 seconds. Return the steering wheel to the straightforward. Position turn off the ignition.