The 2020 Tacoma’s 3.5 L V6 engine takes about 6.0 quarts of oil for a full change with a new filter (roughly 5.7 quarts if you skip replacing the filter). It requires 0W-20 full-synthetic oil.
Capacity and oil specification
Here are the official figures and what to use for a routine oil change on the 3.5 L V6.
- Oil capacity with filter installed: 6.0 quarts (approximately 5.7 quarts if you do not replace the filter).
- Recommended oil type/viscosity: 0W-20 full-synthetic motor oil that meets Toyota specification.
- Notes on variation: Replacing the filter adds roughly 0.3 quart to the capacity; if you drain and reuse the filter, you may need less oil. Always verify with the dipstick after filling.
Oil capacity figures can vary slightly with aftermarket filters and engines with different drive cycles; the values above reflect typical factory specifications for the 2020 Tacoma 3.5 L V6.
Maintenance interval and practical tips
Before listing maintenance guidelines, note how often Toyota recommends changing oil under normal driving and what to watch for.
- Oil-change interval: Toyota's Maintenance Minder typically schedules oil changes around every 10,000 miles (about 16,000 km) under normal driving; more frequent changes may be advised for severe conditions or heavy use.
- Filter and oil change: Replace the oil filter at each oil change; this is included in the standard 6.0-quart capacity.
- Oil type reminder: Always use 0W-20 full-synthetic oil as specified by Toyota for this engine; using a different viscosity can affect performance and warranty coverage.
Following these guidelines helps ensure the engine stays properly lubricated and within warranty coverage. Always refer to the owner's manual or dealership for the exact interval based on your driving conditions and local climate.
Summary
Answer: The 2020 Toyota Tacoma 3.5 L V6 engine uses about 6 quarts of oil with a new filter (roughly 5.7 quarts if you don't replace the filter). Use 0W-20 full synthetic oil and follow Toyota's Maintenance Minder for oil-change intervals, typically around 10,000 miles under normal driving, with more frequent changes if conditions are severe.
What kind of oil does a Toyota 3.5 L V6 take?
This engine requires 0W-20 viscosity for proper variable valve timing operation and fuel efficiency targets, despite some owners preferring heavier grades for perceived protection. Critical Specification Change: Toyota updated the 3.5L V6 oil requirement from 0W-20 to 5W-30 starting in 2020 model year.
What is the most reliable Tacoma engine ever?
The 2015 Toyota Tacoma offers the most reliable 1GR-FE engine of its entire generation. We mentioned how the engine continued to be offered in the 4Runner for even longer, but this was the last Tacoma model year to offer the 4.0L V6 before it was replaced with a 3.5L V6.
What kind of oil does a 3.5 Tacoma take?
What Kind Of Oil Does The Toyota Tacoma Use? Most modern Tacoma models are engineered to run on full synthetic oil, which provides superior lubrication and heat resistance. A Toyota Tacoma runs best on SAE 0W-20 or SW 5W-20.
How much oil does a 2020 Toyota Tacoma 3.5 V6 take?
6.2 quarts
A 2020 Toyota Tacoma takes 6.2 quarts of oil.