There isn’t a single universal TPMS reset button that applies to every Honda CR-V. In many models, you don’t need a dedicated button at all—the system relearns automatically after inflating all tires to the correct pressures and driving at highway speeds. Some trims, however, do include a physical TPMS button located somewhere on or near the dash. The exact location and procedure depend on the model year and trim level.
Where a TPMS reset button might be found (by generation/trim)
Because placements vary, look for a dedicated TPMS control only if your CR-V is a recent model or a higher trim. The following are common possibilities you may encounter:
- Recent CR-V generations (roughly 2017–present): a TPMS button is often on the lower left side of the dash near the steering column. It may be labeled "TPMS" or show a tire icon, sometimes near the headlight leveler switch or the hood release lever.
- Models with a digital instrument cluster or advanced settings: the TPMS option may appear in the vehicle’s settings menu rather than as a physical button.
- Earlier models (pre-2017): many did not include a dedicated TPMS reset button; these typically rely on a drive relearn after inflating tires to the correct pressures.
Because locations vary so much, always check your specific year and trim in the owner’s manual or with a dealer to confirm the exact spot and procedure.
Resetting TPMS when your CR-V has a dedicated TPMS button
- Inflate all tires (including the spare if your model uses it for TPMS) to the recommended pressures listed on the door jamb placard.
- Turn the ignition to ON with the engine off (key in position or push button start).
- Press and hold the TPMS button until the TPMS indicator light blinks slowly and then goes out, or until the display confirms a relearn (exact signal varies by year).
- Drive at a steady speed (around highway speeds) for about 10–20 minutes to complete the relearn process.
- Check that the TPMS light remains off after the drive. If it comes back on, recheck tire pressures and consider a sensor or wheel issue to diagnose at a shop or dealership.
These steps cover models that explicitly provide a TPMS button. If your light doesn’t reset after following them, the system may require service or a sensor replacement.
Resetting TPMS when there is no dedicated button
For CR-Vs without a physical TPMS button, follow these general guidelines to trigger a relearn:
- Ensure all tires are inflated to the recommended pressures on the door jamb placard, including the spare if applicable.
- With the ignition on (engine off), drive the vehicle at a steady speed on a highway or similar road for at least 10–20 minutes. The system should relearn once the car has traveled enough distance under stable conditions.
- If the TPMS warning remains after the drive, check tire pressures again and inspect sensors for damage or corrosion. A faulty or aging sensor often requires professional service.
- Some models may offer a relearn option in the instrument cluster’s settings; if your owner’s manual confirms this, you can initiate relearn from there.
In cases where no button exists and the light stays on, a visit to a tire shop or Honda dealer may be necessary to diagnose sensor faults or perform a factory reset with diagnostic tooling.
Summary
The Honda CR-V does not have a universal TPMS reset button that applies to every year and trim. If your model includes a dedicated TPMS button, its location is usually on the lower left dash near the steering column, sometimes near the hood release or dimmer switch, and the button press is followed by a drive to complete the relearn. If your CR-V lacks a reset button, you typically rely on inflating tires to the correct pressures and driving at highway speeds to trigger an automatic relearn, or you use the vehicle’s settings menu if available. When in doubt, consult the owner’s manual or contact a Honda dealer or tire service professional to ensure the TPMS sensors are functioning correctly.