On a 2019 Cherokee, the oil filter’s location depends on the engine installed. The 2.4L Tigershark I-4 uses a cartridge-style filter inside a round canister mounted to the engine, while the 3.2L Pentastar V6 uses a traditional spin-on filter mounted to the front of the engine.
In 2019, Jeep offered two engines for the Cherokee: a 2.4-liter Tigershark inline-four and a 3.2-liter Pentastar V6. The oil filter setup follows those engine configurations, which affects how you access and replace the filter during routine maintenance. Always consult your owner’s manual or a service manual for your exact VIN since minor production changes can occur between builds.
Oil filter location by engine
Here is a straightforward breakdown of where to expect the oil filter based on the engine in your Cherokee.
- 2.4L Tigershark I-4 (common on most trims): The oil filter is a cartridge inside a round canister mounted on the side of the engine. Access is gained by removing the cap with the appropriate socket, after which the filter element inside is replaced.
- 3.2L Pentastar V6 (available on higher trims): The oil filter is a traditional spin-on unit mounted on the front side of the engine block. To service, unscrew the filter, drain if necessary, and replace with a new unit.
Note that the exact appearance and access can vary depending on the production date and trim level. If there is any doubt, consult the owner's manual or a dealership service department for location confirmation.
How to identify the oil filter on your Cherokee
Use these checks to confirm the filter type in your own vehicle and avoid mistakes during an oil change.
- Check the owner's manual’s maintenance section for the oil filter location and service procedure for your VIN.
- Inspect the engine bay: cartridge filters sit inside a round or square housing with a removable cap; spin-on filters are metal cylinders with a visible threaded end that screws onto the engine.
- Follow the oil flow from the oil pan up toward the engine; this path often reveals the filter’s housing.
Confirming the exact filter location before attempting a change helps prevent damage and ensures you have the correct replacement parts and tools.
Summary
The oil filter location on a 2019 Jeep Cherokee depends on the engine. The 2.4L Tigershark uses a cartridge-style filter inside a canister on the engine side, while the 3.2L Pentastar uses a traditional spin-on filter on the front of the engine. Always verify with the owner’s manual or service documentation for your specific VIN to avoid confusion, and prepare with the right tools and replacement parts.