The 2017 Jeep Renegade with a 2.4 L engine takes about 5 quarts of engine oil for a full change, including the oil filter.
Context: This figure reflects the official capacity for the 2.4 L Tigershark inline-4 used in the Renegade. Always consult the owner's manual or a dealership service bulletin for model-specific guidance, as variations can occur based on configuration or regional specifications. In practice, plan on roughly five quarts to complete a full oil change.
Official oil capacity for the 2.4 L Renegade
The following summarizes the standard oil capacity for the 2.4 L engine when performing a full oil change with a new filter.
- 5 quarts (approximately 4.7 L) of engine oil, including the filter.
Understanding this figure helps ensure you have the right amount of oil on hand and avoid underfilling or overfilling during service.
Practical steps for changing oil (quick guide)
If you are planning a DIY oil change, use the following steps to reach the correct fill after replacing the filter.
- Warm the engine to expand the oil, then park on level ground and turn off the engine.
- Drain the old oil into a suitable receptacle, removing the drain plug to let it flow out completely.
- Remove and replace the oil filter with a new one, lightly oiling the filter gasket with fresh oil.
- Reinstall the drain plug, then slowly pour in the oil—start with about five quarts as a reference point.
- Check the oil level with the dipstick, add small amounts as needed, then run the engine briefly and recheck the level with the engine off.
Note: If you’re unsure about performing an oil change yourself, or if the vehicle is under warranty, have a qualified technician perform the service to ensure proper lubrication and correct torque on fasteners.
Tips for accuracy and safety
Use the viscosity recommended in the owner's manual, and verify the exact capacity for your trim and climate. After filling, recheck the dipstick with the engine off and cold to confirm the level sits in the Full range.
Summary
The 2017 Jeep Renegade with the 2.4 L Tigershark engine uses 5 quarts of engine oil in a full change, including the filter. This figure is the standard capacity, but you should always consult the owner's manual or Jeep service documentation for your specific vehicle configuration and follow proper maintenance steps to ensure accurate oil level and engine health.