There are two air filters in a 2006 Honda Pilot: the engine air filter in the engine bay and the cabin air filter, which sits behind the glove box on the passenger side. This guide explains where to locate each filter and how to replace them.
Engine air filter location
To replace the engine air filter, start with the engine off and the hood raised. The filter is inside a rectangular black plastic housing on the passenger side of the engine bay, near the front of the vehicle. The housing is secured with clips or screws that you will need to release to access the filter.
Follow these steps to replace the engine air filter:
- Open the hood and locate the engine air filter housing on the passenger side of the engine bay.
- Release the clips or remove the screws holding the cover, then lift the cover off to expose the filter.
- Take out the old filter and inspect the inside of the housing for debris or signs of wear.
- Clean the inside of the housing if needed, then insert the new filter with the correct orientation (the arrow on the filter should point toward the engine).
- Reinstall the housing cover and secure the clips or screws firmly.
- Close the hood and run the engine briefly to ensure there are no gaps or unusual noises.
Replacing the engine air filter helps maintain proper air flow and fuel efficiency. Typical replacement intervals vary by environment but are commonly in the 15,000–30,000 mile range.
Cabin air filter location
The cabin air filter in the 2006 Pilot is located behind the glove box on the passenger side. Access typically requires lowering the glove box and removing a small access panel to reveal the filter housing.
Follow these steps to replace the cabin air filter:
- Open the glove box and remove its contents.
- Gently press in the sides of the glove box to release the stops and allow the box to lower; some models use a damper that you may need to disconnect.
- Locate the rectangular cabin air filter cover at the end of the dash near the glove box, and unclip or rotate it to expose the filter.
- Slide out the old filter, then insert the new filter with the arrows pointing toward the interior of the vehicle.
- Reattach the filter cover, lift the glove box back into place, and secure it.
Regular cabin filter replacement improves HVAC efficiency and interior air quality. Typical guidance suggests replacing every 12 months or 15,000 miles, depending on driving conditions and environment.
Summary
In a 2006 Honda Pilot, there are two filters to consider: the engine air filter in the engine bay on the passenger side, and the cabin air filter behind the glove box on the passenger side. Both are accessible to DIY enthusiasts and replacing them as needed helps maintain engine performance and cabin air quality.
What's the fastest a Honda Pilot can go?
130mph
Top Speed of the Honda Pilot
Having ample power, the 2021 Honda Pilot has a 130mph maximum speed. This rating remains the same in each trim option and shows the handling capability the Pilot has.
Where is the air filter on a 2006 Honda Pilot?
The air filter is located here there are four screws that secure the housing. Use an 8 mm or 5/16 socket or a Phillips head screwdriver to loosen the screws securing the filter housing.
What are three symptoms of a clogged cabin air filter?
3 Signs Your Cabin Filter is Clogged
- There's Little Flow. The cabin filter is, essentially, a component of the air conditioner structure in your car.
- Dust. Another sign is is that you're seeing more than the usual amount of dust and debris inside your car.
- Less Vehicle Power.
What is the best engine oil for a Honda Pilot?
Honda Pilot Oil Change
Per the owner's manual, the Honda Pilot will need premium-grade 0W-20 detergent oil with an API Certification seal on the container. Genuine Honda motor oil works best, but you can also use a different engine oil of the recommended viscosity.