The correct filter is Honda’s spin-on oil filter, most often part number 15400-PLM-A01 for the 2007 Accord 2.4L; some production runs may use 15400-PLM-A02. Always confirm with your vehicle’s VIN or the official parts catalog to be sure.
Overview and why the part matters
The 2007 Honda Accord 2.4L uses a standard Honda oil filtration system designed for the K24A series engines. Getting the exact filter helps ensure a proper seal, correct oil flow, and reliable protection for the engine’s bearings and gaskets. While many aftermarket filters claim compatibility, sticking with the OEM designation or a reputable cross-reference reduces the risk of fitment or performance issues.
OEM part numbers and verification
To ensure you purchase the correct filter, refer to the official Honda parts catalog or your car’s VIN. The following OEM options cover most 2003–2008 Accord 2.4L models; however, VIN-specific differences can occur.
- 15400-PLM-A01 — primary OEM oil filter for most 2.4L Accords (2003–2008).
- 15400-PLM-A02 — updated revision used on some VIN ranges or production periods.
For any doubt, verify by cross-referencing your VIN with Honda’s parts lookup or consult a dealer parts department to ensure you receive the exact match for your vehicle.
Aftermarket cross-reference options
If you prefer aftermarket filters, many brands offer filters that are compatible with the 2.4L Honda engines. When shopping, look for products explicitly listed as compatible with the 2003–2008 Accord 2.4L or with Honda’s 15400-PLM-A0x family. Choosing a filter from a reputable manufacturer and ensuring the correct thread size and gasket diameter is essential.
- Wix, Bosch, Purolator, Mann-Filter, and other major brands commonly provide Honda-compatible options labeled for the 2.4L Accord.
Always compare the specific part number or cross-reference against Honda’s catalog or your vehicle’s manual to avoid mismatches.
Replacing the filter: quick, safe steps
Before you begin, prepare the workspace, gather the new filter and fresh oil, and ensure you have the correct tools. The following steps outline a typical oil filter replacement for a 2007 Accord 2.4L.
- Warm up the engine briefly, then park on a level surface and engage the parking brake.
- Lift the car safely and support it with jack stands if you need extra clearance.
- Place an oil drain pan under the engine and remove the drain plug to drain the old oil (and let some oil drain before removing the filter).
- Locate and remove the old oil filter; wipe the mounting area clean.
- Lubricate the new filter’s gasket with a small amount of clean oil, then install it by hand until snug and give it an additional 3/4 to 1 turn (do not over-tighten).
- Reinstall the drain plug, then fill the engine with the recommended oil type and amount for the 2.4L engine.
- Check for leaks, start the engine, and re-check the oil level after a few minutes of idle; top off if necessary.
Following these steps helps ensure a proper seal and accurate oil level after the change.
Summary
For a 2007 Honda Accord 2.4L, the standard oil filter is the OEM Honda part 15400-PLM-A01, with 15400-PLM-A02 as a possible revision for some production runs. If you opt for aftermarket options, choose brands that explicitly list compatibility with the 2.4L Accord (2003–2008) and verify using your VIN or parts lookup. Always follow proper replacement steps to maintain engine protection and oil quality.