The 2019 Camry uses a standard spin-on oil filter (not a cartridge). For the 2.5-liter four-cylinder engine, the OEM filter is 04152-YZZA1, and many reputable aftermarket filters will fit the same size. Confirm the exact part number by checking your engine code or VIN.
Engine options and filter compatibility
In 2019, the Camry offered two main engines: a 2.5-liter inline-four and a 3.5-liter V6. Both use a conventional spin-on oil filter, so the general filter type remains the same. The exact part number varies by engine code, so it’s important to verify your specific configuration.
Spin-on vs. cartridge
These Camry engines use a traditional spin-on oil filter, meaning you replace a complete canister element with a new filter rather than a cartridge. This is the common setup for U.S. market models in 2019.
Filter options and part numbers
Before choosing a filter, understand OEM versus aftermarket options and confirm compatibility with your engine code.
- OEM Toyota filter for the 2.5L engine: 04152-YZZA1
- Aftermarket filters: Many brands (Wix, Bosch, Purolator, Fram, Mobil 1, and others) offer filters that fit Toyota engines; ensure the product lists compatibility with Toyota Camry 2019 or with the corresponding engine code (A25A-FKS for the 2.5L, or 2GR-FKS for the V6)
- Where to buy: Toyota dealer parts, major auto parts retailers, or reputable online shops; bring your VIN or engine code to verify the right filter
In practice, selecting a well-reviewed filter designed for the Camry’s 2019 engine family will work, but sticking with the OEM part guarantees exact fit and proper sealing for your vehicle.
How to replace the oil filter
Follow these steps to replace the spin-on oil filter during an oil change, using the correct oil and safety precautions.
- Warm up the engine briefly, then turn it off and place a drain pan underneath the oil pan. Open the oil filler cap to vent air.
- Loosen and remove the old oil filter using an appropriate filter wrench or by hand, letting the oil drain into the pan.
- Install the new filter by hand until it’s snug, then follow the manufacturer’s torque guideline (usually a light additional turn after the gasket contacts the seat).
- Reinstall or replace the drain plug gasket if applicable, then refill the engine with the recommended oil (0W-20 synthetic for most 2019 Camrys) to the correct capacity.
- Run the engine for a few minutes, check for leaks around the filter, turn off the engine, and recheck the oil level with the dipstick; top up if needed and dispose of the old filter and oil properly.
Regularly replacing the oil filter with a quality filter and the proper oil helps protect the Camry’s engine and maintain performance.
Maintenance tips and buying guidance
Keep these practical tips in mind when selecting and replacing the oil filter for your Camry.
- Always verify compatibility with your engine code (A25A-FKS for the 2.5L, 2GR-FKS for the V6) using your VIN or the service documentation
- Use the recommended oil type—0W-20 synthetic is standard for most 2019 Camry models
- If choosing aftermarket, opt for a reputable brand and ensure the product explicitly states compatibility with Toyota Camry 2019 or with your engine code
Adhering to these guidelines helps ensure an effective seal, proper filtration, and reliable engine protection during oil changes.
Summary
The 2019 Toyota Camry uses a conventional spin-on oil filter. For the most common 2.5L engine, the OEM filter is 04152-YZZA1, with many reputable aftermarket filters available that fit Toyota engines. Always confirm the exact part number for your engine code and VIN, and follow proper oil-change procedures to maintain engine health.