The 2004 Honda Odyssey uses a standard spin-on oil filter for its 3.5-liter V6 engine. The typical OEM replacement is Honda part number 15400-PLM-A01, with some production runs using related filters; always verify by checking the old filter or your vehicle’s VIN to confirm the exact cross-reference.
Oil filter type and engine compatibility
The Odyssey’s 3.5L V6 (J-series) relies on a traditional spin-on oil filter that screws onto the engine block. This is not a cartridge-style system. You can use either an OEM Honda filter or a reputable aftermarket filter, provided it matches the thread size and gasket of the 3.5L V6. Both conventional and synthetic oils are compatible with these filters, and regular replacement is part of standard maintenance.
OEM part numbers and compatibility
Use the following references as general guidance, but remember the exact number can vary by production date or region. When in doubt, compare with the old filter or consult the retailer’s VIN-based lookup.
- Honda OEM filter commonly used on the 2004 Odyssey: 15400-PLM-A01
- Alternate Honda OEM number that may appear on some production runs: 15400-PLM-A02
Aftermarket filters marketed as compatible with the Honda 3.5L V6 (J35) are widely available. When choosing one, ensure it is explicitly listed as compatible with the 3.5L V6 engine and matches the engine’s thread size and gasket diameter.
Aftermarket considerations
If you opt for an aftermarket filter, verify compatibility using the engine code (J35) and the Odyssey model year. Look for reputable brands and confirm the filter’s dimensions and gasket fit to avoid leaks or improper sealing. If you aren’t sure, ask your parts retailer or check the vehicle’s manual for the exact cross-reference.
How to replace the oil filter
Before you begin, gather the right filter and the correct quantity of oil recommended for the 2004 Odyssey. Here are practical steps to follow for a standard oil-and-filter change.
- Warm up the engine briefly, then park on level ground and apply the parking brake.
- Loosen and remove the engine oil drain plug to drain the old oil into a pan; replace the drain plug once drained.
- Position a drain pan under the oil filter and use a filter wrench to remove the old filter. Be prepared for some residual oil to spill.
- Wipe the mounting surface clean and lightly coat the gasket on the new filter with fresh oil.
- Screw the new filter on by hand until snug, then give it an additional small turn—do not overtighten.
- Fill the engine with the recommended oil quantity and type for the 3.5L V6; typically around several quarts, depending on exact model and filter change.
- Run the engine, check for leaks, and recheck the oil level after a few minutes of operation.
Concluding: Replacing the filter properly helps maintain optimal oil pressure and engine protection, and resetting the oil level after the change is essential.
Maintenance tips and common pitfalls
Key tips to keep in mind include using the correct filter type for the 3.5L V6, not over-tightening the filter, and ensuring the oil is the appropriate grade and quantity. A common pitfall is using an incompatible aftermarket filter that doesn’t match the thread or gasket size, which can lead to leaks or oil pressure issues. Always verify fitment for your exact vehicle configuration.
Summary
The 2004 Honda Odyssey uses a standard spin-on oil filter for its 3.5L V6 engine. The typical OEM replacement is 15400-PLM-A01, with some variations by production run. Confirm the correct part by inspecting the old filter or using VIN-based lookup, and follow proper replacement steps to maintain engine health. When in doubt, consult the parts retailer or the owner’s manual for the exact cross-reference.
What type of oil does a 2004 Honda Odyssey use?
Oil Grade: API*
| Viscosity: | 5W-20, 0W-20 (All TEMPS) - 0W-20 has been approved to be used in this application |
|---|---|
| Capacity: | 4.2 quarts. W/O FLT, w/of. After refill check oil level. |
| Capacity: | 4.5 quarts (with filter). W/ FLT. After refill check oil level. |
| Torque: | 29 ft/lbs (Oil Drain Plug) |
Where is the oil filter on a 2004 Honda Odyssey?
The uh filter now to catch the oil when it comes down cuz uh some always comes down and then get your um oil filter wrench. And crank it loose. Again this guy shouldn't be too tight.
What oil filter does a Honda Odyssey use?
Honda Genuine engine Oil Filter / Same as 15400-RTA-003.
What is the number for the Fram air filter on a 2004 Honda Odyssey?
CA9481
FRAM Extra Guard Air Filter, CA9481 Fits select: 2002-2004 HONDA ODYSSEY.