The 2016 Dodge Dart with the 2.4-liter Tigershark engine takes about 5.5 quarts (roughly 5.2 liters) of engine oil for a full change with a new filter, using the grade listed in the owner's manual (commonly 5W-20 full synthetic).
The 2.4L engine in this Dart belongs to Chrysler’s Tigershark family, and oil capacity can vary slightly depending on factors such as whether a filter is replaced and whether the engine has certain options like an oil cooler. This article explains the official figure, recommended oil, and practical tips for ensuring the correct fill.
Official oil capacity for the 2.4L Tigershark
The standard capacity for the 2016 Dart’s 2.4L engine, with a new oil filter, is about 5.5 quarts (5.2 liters). This is the figure most service manuals and dealer sheets cite for a typical oil change. Some sources note a range depending on equipment, but 5.5 quarts with a filter is the baseline reference.
Recommended oil grade and change interval
For this engine, a 5W-20 full synthetic oil is usually recommended, though some climates or dealer guidance may call for 5W-30. Follow the exact specification in your owner's manual. Typical oil-change intervals range from about 6,000 to 7,500 miles under normal driving conditions, but always adjust for driving style and environment as advised by Chrysler/Fiat.
Practical tips for filling and checking oil
When performing an oil change, replace the oil filter and use the correct grade. After adding oil, run the engine briefly, shut it off, wait a few minutes, and then recheck the level with the dipstick. Avoid overfilling, which can cause engine damage. If in doubt, consult a certified mechanic or your dealership.
Summary
The 2016 Dodge Dart with the 2.4L Tigershark engine typically requires about 5.5 quarts (5.2 liters) of oil when changing the oil with a new filter, using the grade specified in the manual (commonly 5W-20 full synthetic). Always verify the exact figure and oil type in your owner's manual and confirm with a dealer if your vehicle has atypical options.