The 2019 Jeep Cherokee with the 3.2-liter V6 requires SAE 0W-20 full-synthetic motor oil. This specification is listed by the manufacturer and should be followed to protect the engine and maintain warranty coverage.
Oil type and specifications
Understanding the exact oil specification helps ensure proper lubrication, performance, and longevity for the 3.2L V6 engine used in the Cherokee’s 2019 lineup.
Recommended viscosity and certifications
For the 3.2L V6, Jeep specifies 0W-20 full-synthetic motor oil. The oil should meet API SN (or newer) requirements and be suitable for Chrysler’s OEM standards. Using a 0W-20 synthetic that carries the Mopar/Chrysler approval or MS-6395-compliant spec is advised to ensure compatibility with the engine’s tolerances and the vehicle’s maintenance systems.
- 0W-20 full-synthetic motor oil
- Meets or exceeds API SN (or newer) and ILSAC standards
- Mopar/Chrysler MS-6395 compatibility (OEM specification)
- Approximate capacity: about 5 quarts with filter
Choosing the correct oil is essential for optimal performance and to maintain warranty coverage. When in doubt, consult the owner’s manual or a dealership service advisor to confirm the exact specification for your vehicle’s VIN.
Oil capacity and maintenance intervals
Knowing how much oil the engine holds and when to change it helps you plan maintenance and avoid low-oil scenarios that could harm the V6’s performance.
Capacity and recommended change intervals
- Oil capacity (with filter): approximately 5 quarts
- Normal-service oil-change interval: typically up to about 7,500 miles (12,000 km) under normal driving with synthetic oil, or per the vehicle’s Oil Life Monitor
- Severe-service interval: commonly 3,000–5,000 miles depending on driving conditions (e.g., lots of idling, short trips, extreme temps)
Always follow the vehicle’s maintenance minder and the owner’s manual for exact intervals, as the Oil Life Monitor may adjust recommendations based on driving habits and conditions.
Where to source the right oil
To ensure you’re using the correct oil, you can rely on a few reliable channels. Use oils that meet the Jeep/Mopar specification and are labeled 0W-20 full synthetic.
- OEM/Mopar-branded 0W-20 full-synthetic oil sold through Jeep dealerships
- Reputable third-party brands that explicitly meet API SN (or newer) and Chrysler MS-6395 for 0W-20 synthetic
- Official service centers or trusted auto parts stores that can verify specification on the label
When purchasing oil, always check the bottle for the 0W-20 designation and the appropriate approvals to ensure compatibility with the 3.2L V6 engine.
Summary
The 2019 Jeep Cherokee’s 3.2L V6 uses 0W-20 full-synthetic oil, with an approximate capacity of 5 quarts per change. Follow the Oil Life Monitor or factory-recommended intervals, and use a Mopar-approved or equivalent API SN+ 0W-20 oil to maintain performance and warranty compliance. For exact specifications tailored to your VIN, refer to the owner’s manual or consult a Jeep service professional.