The Infiniti Q60 uses a standard 12-volt automotive battery for starting and all onboard electronics. In most models, this is a conventional 12V lead-acid unit, though some later or higher-load variants may use an AGM (absorbed glass mat) 12V battery to better handle electrical demand. There is no high-voltage traction battery in the standard Q60 lineup.
This article explains what to expect across common model years and trims, how to identify the exact battery in your car, and how to replace and maintain it properly.
Battery type overview
Below is a concise breakdown of the 12-volt battery configurations you’re likely to encounter on Infiniti Q60 models. Note that exact specifications can vary by year and market, so always verify with your vehicle’s battery label or owner’s manual.
- All Infiniti Q60 models use a 12-volt automotive battery for starting, lighting, and electronics; there is no high-voltage traction battery in the standard car.
- Most earlier Q60s used a conventional lead-acid battery; some later or higher-load variants may use an AGM 12-volt battery to handle extra electrical demand.
- There is no plug-in hybrid or full-electric version of the Q60 in the mainstream lineup; the 12-volt battery is distinct from any propulsion battery.
In short, if you need to replace the battery, you’re dealing with a 12-volt unit rather than any high-voltage or hybrid battery type. Check the label on your battery or the owner’s manual for the exact type used on your vehicle.
How to identify the correct battery
Identify the battery type by inspecting the label on the battery itself. It will indicate whether the battery is standard flooded lead-acid or an AGM maintenance-free type. The owner's manual or the Specifications section on Infiniti’s site will also list the recommended battery characteristics and group size for your year and trim.
Battery replacement and care
When it’s time to replace or service the battery, follow these steps and tips to ensure a safe, proper replacement and long battery life.
- Before you start, make sure the engine is off and the parking brake engaged. Identify the negative (-) and positive (+) terminals on the battery.
- General replacement steps: disconnect the negative terminal first, then the positive; remove the hold-down bracket; swap in a new battery with the same spec; reconnect positive first, then negative; reinstall any covers and brackets; reset electronics if required.
- After installation, apply anti-corrosion spray on terminals and ensure snug connections; periodically inspect for corrosion and clean as needed.
Battery maintenance is best done with regular checks, especially in extreme climates. If the vehicle experiences rapid dimming, slow crank, or warning lights, test the battery health and alternator as part of routine maintenance.
Summary
The Infiniti Q60 relies on a 12-volt automotive battery for its electrical system, with no high-voltage traction battery in the standard setup. Depending on year and trim, the 12V unit may be conventional lead-acid or an AGM variant, but it is not a plug-in or fully electric battery. When replacing, follow standard safety procedures and verify the exact specification from the battery label or owner’s manual.