The interior fuel-door release on the driver’s side pop the door, then you access the filler from the left-rear of the vehicle. Some trims use capless fueling with no gas cap to remove; others use a traditional gas cap that must be unscrewed and replaced after fueling.
Where to find the fuel-door release
In the 2025 Honda CR-V, the primary step is locating the fuel‑door release inside the car. It is typically on the lower-left side of the dash near the driver's knee. Pulling this lever or switch releases the exterior fuel door so you can access the filler neck from outside.
Capless fuel system (no gas cap)
Some trims use a capless fueling system. There is no cap to remove; after the door is released, you simply insert the nozzle into the capless filler neck to begin fueling.
Steps to follow before fueling
- Ensure the vehicle is unlocked and the engine is off.
- Locate and pull the interior fuel-door release lever on the lower-left dash near the driver’s knee.
- Walk to the left rear of the vehicle and open the exterior fuel door by giving it a firm press on the edge; the door is spring-loaded and should pop open.
- Proceed to fuel using the capless filler neck.
After fueling, remove the nozzle and close the fuel door until it latches securely. The door should be fully closed to prevent leaks or debris entry.
Concluding note: Capless systems simplify the process by removing the need to handle a gas cap, but you still must ensure the door is fully closed after fueling.
Traditional gas cap (with cap)
On trims that still use a conventional gas cap, you will remove and later reinstall a cap after opening the door.
Steps to follow before fueling
- Ensure the vehicle is unlocked and the engine is off.
- Locate and pull the interior fuel-door release lever on the lower-left dash near the driver’s knee.
- Walk to the left rear of the vehicle and open the exterior fuel door by pressing the edge; the door will swing open to reveal the filler neck and the gas cap.
- Remove the gas cap by turning it counterclockwise and set it aside on a safe surface or tether it if your model provides a holder.
Steps to fueling and resealing
- Insert the fueling nozzle into the filler neck and fuel to the recommended level; the nozzle will stop automatically at full.
- Remove the nozzle and replace the gas cap by turning it clockwise until you hear a click, ensuring it is snug.
- Close the exterior fuel door until it latches securely.
Concluding note: Always ensure the gas cap is securely tightened to maintain proper seal and prevent the check-engine light from illuminating due to a loose cap.
What to do if the door won’t open
If the interior release does not seem to disengage the door, first verify that the car is unlocked. If the door remains stubborn, consult the owner’s manual for model-specific guidance or contact a Honda dealer for assistance. Do not force the latch, as that can cause damage.
Summary
Opening the 2025 Honda CR-V’s gas tank starts with the inside fuel-door release located on the driver’s lower-left dash. After releasing, access the capless filler or traditional gas cap according to your trim. Capless fueling requires no cap removal, while traditional-cap models require removing and resealing the cap. Always ensure the door is fully closed after fueling to maintain safety and proper sealing.