To reset the Tire Pressure Monitoring System (TPMS) on a 2009 Civic, ensure all tires are inflated to the recommended cold pressures, then use the appropriate reset method for your model and drive the car to relearn the sensors. The exact steps depend on whether your trim has a dedicated TPMS button or uses the information display.
Two common reset methods
The 2009 Civic can reset TPMS through either a dashboard button or the vehicle’s information-display menu. Below are the two pathways, with steps for each approach. Choose the method that matches your car’s controls.
Method A: Using the TPMS reset button (if equipped)
Before performing this method, confirm that all tires are inflated to the recommended cold pressures. A correct starting point helps the system relearn accurately.
- Turn the ignition to ON with the engine off.
- Press and hold the TPMS reset button until the TPMS indicator light in the dash blinks slowly, then release.
- Drive the vehicle at highway speed (typically around 30–50 mph or 50–80 km/h) for about 10–20 minutes to complete the relearn process.
- Once relearning is complete, the TPMS light should stop blinking and settle to its normal state.
After completing these steps, the system should recognize the new tire pressures. If the light stays on or blinks after driving, recheck tire pressures and inspect for leaks or sensor issues.
Method B: Using the information/display menu (no TPMS button)
If your Civic doesn’t have a dedicated TPMS switch, you’ll usually reset TPMS through the driver information display. This path relies on the vehicle’s onboard menus.
- Turn the ignition to ON with the engine off, then access the driver information display using the steering-wheel controls.
- Navigate to Settings or Vehicle, then select TPMS or Tire Pressure Monitoring.
- Choose Reset or Learn, then confirm to start the relearn process.
- Drive at a steady speed (about 30–50 mph / 50–80 km/h) for 10–20 minutes to complete the relearn.
After reset, monitor the dash indicator. If the light goes out or remains steady, the relearn is likely successful. If it stays on, confirm tire pressures are correct and consider a professional check for sensor issues.
Troubleshooting and tips
If the TPMS light remains on after attempting a reset, try the following checks to identify common causes and next steps.
- Double-check that all tires (including the spare, if equipped with a sensor) are inflated to the manufacturer’s recommended pressures when cold.
- Look for a tire with a slow leak or persistent underinflation that could prevent a successful reset.
- Inspect wheels and sensors for physical damage, corrosion on the sensor mounts, or a worn sensor battery that may require replacement.
- Note that some aftermarket tire replacements or sensor issues can prevent the relearn from completing; if in doubt, have a tire shop or Honda dealer run a TPMS diagnostic.
If troubleshooting doesn’t resolve the issue, a professional inspection can verify sensor health and perform any necessary reprogramming or sensor replacement.
How to verify the reset
Confirmation comes from both correct tire pressures and a successful relearn indication on the dash. After the relearn drive, the TPMS light should:
- No longer flash and remain off, or
- Remain steady if the system has completed relearning without issues.
Some models display a message confirming that TPMS has been reset. If a warning persists, recheck pressures, inspect sensors, or seek professional service.
Summary
Resetting TPMS on a 2009 Honda Civic typically involves inflating all tires to the recommended cold pressures and then using either a dedicated TPMS reset button or the vehicle’s information-display menu to initiate a relearn. Drive at a steady speed for 10–20 minutes to complete the process. If the warning remains after these steps, inspect tire pressures and sensors, and consult a tire or Honda service professional to diagnose any sensor issues.