For a 2014 Honda Civic, oil capacity depends on the engine: the 1.8-liter four-cylinder holds about 4.4 quarts of engine oil with the filter installed, while the 2.4-liter four-cylinder used in the Civic Si holds about 5.5 quarts.
That year offered two four-cylinder engine options, and the total oil capacity varies with the design. The following details break down the capacities by engine and provide practical guidance on how to handle an oil change, including keeping the level correct with a dipstick test. Always refer to the owner’s manual for your exact trim and engine code.
Engine options and their oil capacities
Before listing the capacities, note that these figures include the oil filter and reflect typical full-change quantities. Use them as a starting point, then confirm with your vehicle’s manual and dipstick measurements after servicing.
- 1.8-liter four-cylinder (LX, EX, EX-L, most trims): about 4.4 quarts (4.2 liters) of engine oil with filter.
- 2.4-liter four-cylinder (Civic Si): about 5.5 quarts (5.2 liters) of engine oil with filter.
Capacities can vary slightly by production run or if a different filter is installed. After performing a full change, fill to the recommended level on the dipstick and recheck once the engine has cooled.
Oil type and maintenance tips
Honda generally specifies 0W-20 full-synthetic engine oil for most 2014 Civics. Use a quality oil that meets Honda’s specifications and pair it with a compatible oil filter. Follow the maintenance schedule in the owner’s manual, which typically suggests oil changes every 7,500 miles under normal driving conditions, or as recommended for your driving Habits.
Is your Civic Si different?
The Civic Si uses the 2.4-liter engine with a higher oil capacity (about 5.5 quarts with filter), but the recommended grade commonly remains 0W-20 for many engines. Always verify the exact engine code and consult the manual for your specific trim.
How to check and top off oil
To ensure the oil level is correct after a change: park on a level surface, run the engine briefly then let it cool, pull the dipstick, wipe it clean, reinsert fully, and read the level. If the level is low, add small amounts of oil and recheck until the dipstick shows within the acceptable range. Do not overfill.
Summary
For a 2014 Honda Civic, oil capacity depends on the engine: approximately 4.4 quarts for the 1.8L engine and about 5.5 quarts for the 2.4L Si. Use 0W-20 full-synthetic oil and verify the exact specification and capacity in your owner’s manual for your particular trim and engine code. Properly checking with the dipstick after filling helps ensure a correct level and engine protection.