How much oil does a 2019 Chrysler 300 3.6 L take?

The 2019 Chrysler 300's 3.6 L V6 engine takes about 5.7 quarts (5.4 liters) of engine oil when performing a full oil change with a new filter.

Official oil capacity

The standard capacity for the 3.6 L Pentastar V6 used in the 2019 300, including the new filter, is:

• 5.7 quarts (5.4 liters) of engine oil with a new filter

Note: Depending on the exact service procedure, drain amount and residual oil can vary slightly. Always verify level with the dipstick after the fill and refer to the owner's manual for the recommended oil viscosity.

Oil type and practical notes

For most climates, Chrysler recommends synthetic 0W-20 engine oil to meet modern specifications. Always check the owner's manual for the exact viscosity and API/ILSAC standards required in your region, as some conditions may allow alternate grades.

Summary

The 2019 Chrysler 300 with the 3.6 L engine requires approximately 5.7 quarts of oil when performing an oil and filter change. Use the recommended synthetic oil (commonly 0W-20) and verify the final level with the dipstick after filling. Always follow the owner's manual for precise guidelines and intervals.