The 2017 GMC Yukon with the 5.3-liter V8 engine takes about 8 quarts (roughly 7.6 liters) of engine oil for a full change with a new filter.
Here is a detailed look at the capacity figures and related considerations so you can plan oil changes with confidence.
Oil capacity details
Before listing quantities, note that capacity refers to the total oil the engine holds after a complete drain and filter replacement.
- With filter: 8 quarts (7.6 L)
- Without filter: 7 quarts (6.6 L)
- Recommended oil viscosity and spec: Dexos1 Gen 2 0W-20 is commonly specified; check your owner's manual for your climate and local requirements.
After performing an oil change, always recheck the level using the dipstick and top up as needed to reach the full mark.
Oil type and climate considerations
The Yukon 5.3L typically requires Dexos1 Gen 2 0W-20 in many regions, with some climates allowing 5W-30. Always verify the exact specification in your owner's manual or with a GM dealer, as requirements can vary by market and model year.
- Most engines in this family use Dexos1 Gen 2 0W-20 as the standard recommendation.
- If you live in a very hot climate or have specific dealership guidance, your manual may suggest a different viscosity.
When in doubt, follow the manual and consult a technician to ensure the oil meets GM’s Dexos specification for your vehicle.
Practical oil-change tips
Useful steps to ensure a proper change and accurate oil level are outlined here. This list helps you prepare and execute a safe, thorough oil change.
- Warm the engine briefly to expand the oil but avoid handling hot components.
- Use a proper funnel and a clean drain pan; replace the oil filter with a genuine GM filter.
- Drain the old oil completely, then install the drain plug securely before refilling.
- Pour in 8 quarts (with new filter) of the recommended oil, then run the engine to circulate the oil.
- Turn off the engine, wait a few minutes, and recheck the dipstick to confirm the level reaches the full mark.
- Dispose of used oil and filter at an approved recycling facility.
Note: Do not overfill the engine, as excess oil can create pressure and leaks. If you accidentally add too much, drain a small amount and recheck the level.
Summary
For a 2017 GMC Yukon equipped with the 5.3L V8, plan for about 8 quarts (approximately 7.6 liters) of engine oil for a full change with a filter. If you’re not replacing the filter, the total is typically around 7 quarts (6.6 L). Always confirm the exact specification in your owner's manual and use Dexos1 Gen 2 0W-20 unless your climate or dealer guidance states otherwise. Finish with a dipstick check to ensure the level is at the full mark.