The 2017 Chevy Trax with the 1.4-liter turbo engine requires about 4.2 quarts (4.0 liters) of engine oil when performing a full oil change with a new filter.
The Trax uses a small turbocharged four-cylinder engine. The official specification for this engine lists an oil capacity of 4.2 quarts (4.0 liters) with the filter installed. The exact amount can vary slightly depending on the oil filter model and whether you drain the pan completely. Always confirm the figure in the owner's manual or GM's service information for your VIN.
Oil capacity and specification
Key capacity and specification details you should know when planning an oil change for the 1.4L turbo engine in the 2017 Trax:
- Oil capacity with filter: 4.2 quarts (4.0 liters).
- Recommended oil type: Dexos1 Gen 2 5W-30 (or equivalent meeting GM Dexos1 Gen 2 specifications).
Note: Use the correct filter and oil specification to ensure accurate capacity and proper lubrication. After adding oil, verify the level with the dipstick and adjust as needed to stay within the full-mark range.
Practical steps for an oil change
Follow these steps to carry out an oil change on the 2017 Trax 1.4L turbo safely and effectively.
- Gather supplies: Dexos1 Gen 2 5W-30 oil, a compatible oil filter, a drain pan, a funnel, wrenches, and a drain plug washer if needed.
- Warm the engine briefly to help drainage, then park on a level surface and engage the parking brake.
- Place the drain pan under the sump drain plug, remove the plug, and allow the old oil to drain completely.
- Remove the old oil filter, install the new filter per the manufacturer's instructions, and lubricate the gasket with a bit of new oil.
- Replace the drain plug after the oil has drained, then fill with about 4.0 quarts of oil, checking the level with the dipstick as you go.
- Start the engine, run for a minute, turn off, and recheck the oil level; top up as needed to reach the full mark.
If you’re unsure about performing an oil change yourself, consider having a professional service the vehicle to ensure the correct oil, filter, and torque specifications are used.
Summary
The 2017 Chevy Trax with the 1.4L turbo engine uses roughly 4.2 quarts (4.0 liters) of engine oil when changing the oil with a filter, using Dexos1 Gen 2 5W-30 oil. Always verify the exact capacity for your specific vehicle and ensure the oil level sits correctly on the dipstick after refilling.