The 2016 Audi Q5 with the 2.0-liter turbocharged engine typically requires about 5.0 quarts (roughly 4.7 liters) of engine oil when changing the oil with a new filter. This is the standard figure cited in owner manuals and service data, though the exact amount can vary slightly depending on the filter and how completely the oil drains.
Capacity specifics and practical guidance
Below is a quick reference based on the official specification and common service practice:
- Oil capacity (including the filter): approximately 5.0 quarts (about 4.7 liters).
- Note: The published figure is typically the total capacity with the filter; the actual amount used for a given change may vary slightly due to filter size and drainage.
After adding oil and running the engine, recheck the level with the dipstick and top up as needed to reach the correct level. Do not overfill, as that can cause engine damage.
Additional considerations
Oil type and climate recommendations
Audi generally specifies synthetic engine oil that meets VW standards. For the 2.0 TFSI in this model, common viscosity options are 5W-40 or 0W-40, depending on climate and market. Always consult the owner's manual or your dealer for the exact specification applicable to your vehicle.
In summary, plan for about 5 quarts of oil for a full change with a new filter, then verify the level with the dipstick and adjust if necessary. Keeping a little extra on hand can help ensure you can top off without a return trip to the store.
Summary
The 2016 Audi Q5 2.0 TFSI generally takes around 5 quarts (approximately 4.7 liters) of engine oil when performing a full change with a new filter. Confirm the exact specification in your owner's manual and use the dipstick to ensure a precise final level.