The 2015 Honda Fit with a 1.5-liter engine uses about 3.7 quarts of engine oil with the filter, and the recommended viscosity is 0W-20 synthetic oil. After adding oil, fill to the full line and recheck with the dipstick.
In more detail, the official capacity is 3.7 quarts (3.5 liters) with the oil filter installed. Without the filter, the engine holds around 3.4 quarts (3.2 liters). Honda commonly specifies 0W-20 oil for this engine; 5W-20 can be used if 0W-20 isn’t available, but prolonged use of a different viscosity is not ideal. Maintenance intervals via Honda’s Maintenance Minder typically run about 7,500 miles with synthetic oil (or more frequently with conventional oil), but always follow the owner’s manual and the dashboard minder for your vehicle.
Capacity and viscosity
Key figures you need when planning an oil change for the 2015 Fit’s 1.5L engine.
- Oil capacity with filter: 3.7 quarts (3.5 liters)
- Oil capacity without filter: 3.4 quarts (3.2 liters)
- Recommended viscosity: 0W-20 (5W-20 can be used if 0W-20 is unavailable)
When topping up after an oil change, always verify the level with the dipstick and avoid overfilling.
Oil change steps
If you’re planning to do the change yourself, here are the general steps to follow. This is a practical guide; consult the service manual for exact torque specs and procedure details.
- Warm up the engine briefly, then park on a level surface and gather supplies (oil, new filter, drain pan, funnel, wrench).
- Raise the front of the car safely and place a drain pan beneath the oil pan.
- Remove the drain plug and let the old oil drain completely.
- Remove the old oil filter and replace it with a new filter, lubricating the seal with a bit of new oil.
- Reinstall the drain plug and tighten to the specified torque.
- Pour in the new oil (start with the capacity for the filter-included figure, about 3.7 quarts) using a funnel.
- Check the oil level with the dipstick, adding more oil if necessary to reach the full mark.
- Start the engine, check for leaks, then recheck the oil level after a few minutes of idle and adjust if needed.
Tip: Use the recommended oil type and a new filter, and avoid overfilling to prevent engine issues.
Maintaining the Fit’s oil health
Additional considerations for long-term engine health include sticking to the Honda Maintenance Minder guidelines, using the recommended 0W-20 oil, and respecting temperature-related viscosity recommendations. If you drive in extremely hot or cold conditions, confirm that your chosen oil meets those needs and consider following service advisories from Honda or a trusted technician.
Summary
For the 2015 Honda Fit 1.5, you should plan on about 3.7 quarts of engine oil with the filter, using 0W-20 synthetic oil (5W-20 is an acceptable alternative if 0W-20 isn’t available). After a change, fill to the full line and verify with the dipstick. Oil change intervals typically run around 7,500 miles with synthetic oil via the Maintenance Minder, but always confirm with your manual and vehicle minder for your specific driving conditions.