The 2013 Ford Edge with the 3.7-liter V6 engine takes about 5 quarts of engine oil when performing an oil change with a new filter, with 5W-20 being the typical recommended viscosity. This article outlines the official capacity, recommended oil grade, and practical maintenance guidance.
Context: This piece provides the standard capacity figure drawn from Ford’s service literature and owner manuals, along with guidance on oil grade, how to perform a change, and tips to ensure proper level and leak-free operation.
Capacity and what it means for maintenance
The 3.7L Duratec V6 used in the 2013 Edge is listed with an oil capacity of roughly 5.0 quarts when you replace the oil and the filter. This figure is the common reference used by manuals and service guides for this engine. If you use a different or aftermarket filter, the total may vary slightly, but 5 quarts is the standard baseline to expect.
Recommended oil grade and climate considerations
Ford typically specifies 5W-20 for the 3.7L V6 in most regions. In hotter climates or under certain operating conditions, some manuals or dealerships may approve 5W-30; always verify the exact specification for your vehicle’s region and VIN with the owner’s manual or a Ford dealer.
Practical tips for a proper oil change
When performing an oil change, install a new filter, use the correct volume (about 5 quarts for this engine), and then check the level with the dipstick after recent operation and cooling. Start the engine briefly to circulate the oil, check for leaks, and recheck the dipstick to ensure the oil is within the full range.
Summary
To recap, the 2013 Ford Edge 3.7L V6 generally requires about 5 quarts of engine oil when changing the oil and filter, with 5W-20 as the standard recommended viscosity (5W-30 may be acceptable in some conditions). Always confirm the exact specification in your owner's manual or with a Ford dealer for your specific vehicle. Regular maintenance and correct oil level are key to optimal engine performance.