The 2012 Honda Civic with the 1.8-liter engine typically requires about 4.7 quarts (roughly 4.4 liters) of engine oil for a full change with a new filter, using 5W-20 oil. Always confirm with your owner's manual or dealership for your specific VIN, as exact figures can vary by market or engine variant.
Official capacity and oil type
Here are the commonly cited capacity figures and the recommended oil grade for the Civic 1.8L to help you plan an oil change and avoid overfilling.
- Oil capacity with filter: 4.7 quarts (4.4 liters).
Note: Oil capacity figures can vary slightly by market or engine code. Always verify with the owner's manual or a dealer if you have a distinct variant or aftermarket parts.
Practical oil-change steps
When performing the service, follow these steps to ensure the engine receives the proper amount of oil and a new filter is installed correctly.
- Warm up the engine briefly, then park on a level surface and apply the parking brake.
- Raise the car if needed and place a drain pan beneath the oil pan; remove the drain plug to empty the old oil.
- Replace the oil filter with a new one, and reinstall the drain plug, torquing to spec.
- Pour in about 4.5 quarts of oil to start, then check the level with the dipstick; add more in small increments until the dipstick shows full (between the two marks).
- Reinstall the oil filler cap, wipe away any spills, and start the engine to circulate oil; check for leaks.
- After a few minutes, recheck the dipstick and top off if needed to the full mark.
Tip: Always confirm the level after the engine has cooled for a minute and the oil has settled. Honda specifies 5W-20 oil for most 2012 Civics.
Notes and regional variations
Oil capacity and viscosity recommendations can vary by market and engine variant. If you have the hybrid or a different trim, consult the exact service manual for your VIN.
Summary: For a 2012 Honda Civic 1.8L, plan on about 4.7 quarts (4.4 liters) of oil for a full change with a new filter, using 5W-20 oil. Start with roughly 4.5 quarts, then top off to the full mark after checking the dipstick, and follow the steps outlined above. Always refer to your manual for your specific vehicle.
What oil does a 1.8 Honda Civic take?
What Oil Does a Honda Civic Take? Modern Honda Civics require full synthetic 0W-20 engine oil, a specific viscosity grade providing optimal protection for Civic engine components while contributing to improved fuel efficiency.
How much oil does a 2012 1.8 Honda Civic take?
about 3.9 quarts
The Honda Civic with a 1.8L engine typically requires about 3.9 quarts (3.7 liters) of oil. Keeping up with regular oil changes is crucial for preventing engine wear and ensuring smooth operation.
How much oil do I put in my 2012 Honda Civic?
So this is really nice it also tells you the filling capacity. So this since this is a 1.8 liter this is going to be 3.9 quarts or 3.7 L of new oil that'll be in there.
How much oil does a 2012 Civic 1.8 use?
3.7 liters
2012 Honda Civic Oil Capacity and Type
The Civic's 1.8-liter engine needs 3.7 liters of oil, while the 2.4-liter engine model needs 4.2 liters of oil.