Approximately 4.5 quarts for the 2.0-liter engine and about 4.7–5.0 quarts for the 2.4-liter engine, including a fresh oil filter.
In this guide, we break down the exact capacities by engine, explain how to verify the level, and offer oil-grade recommendations to keep the Caliber running smoothly.
Oil capacity by engine
The 2010 Dodge Caliber was offered with two gasoline powerplants. Because capacity depends on the engine and the filter, the numbers vary slightly. Use the dipstick and the owner's manual to confirm for your VIN.
- 2.0-liter I4 World Engine: about 4.5 quarts (4.3 liters) of oil with a new filter.
- 2.4-liter I4: about 4.7–5.0 quarts (4.5–4.7 liters) of oil with a new filter.
Capacity figures can vary by exact engine variant, aftermarket filter choices, and whether the oil includes a filter. Always top up to the full mark on the dipstick after an oil change and recheck after a few minutes of settling.
Oil grade and maintenance tips
Choosing the right oil grade and following regular maintenance is essential for engine longevity in the Caliber.
- Recommended viscosity: 5W-20 for most 2010 Caliber engines. In very hot climates or heavy duty use, 5W-30 may be acceptable if specified by the manual.
- Oil type and spec: Use a high-quality API-certified oil; a synthetic blend is commonly recommended, with full synthetic acceptable if you prefer. Look for certificates like API SN/SM and ILSAC GF-5 or newer.
- Change interval: Follow the owner's manual. With conventional oil, expect roughly every 3,000–5,000 miles (4,800–8,000 km). If using synthetic oil, intervals can extend to about 5,000–7,500 miles (8,000–12,000 km) or as recommended by Chrysler for your climate and driving conditions.
Tip: Always check the dipstick when the engine is cold or after it has rested for a few minutes; wipe clean, reinsert fully, then pull out to read the level. If low, add gradually in small increments until the oil reaches the full mark, avoiding overfill, which can cause engine issues.
Summary
For a 2010 Dodge Caliber, oil capacity is engine-dependent: roughly 4.5 quarts for the 2.0L and about 4.7–5.0 quarts for the 2.4L, with a new filter installed. Use 5W-20 (or 5W-30 in certain conditions) and follow the recommended change intervals from the manual to maintain engine health.
What kind of oil goes in a Dodge Caliber?
Mobil 1 – Extended Performance 5W-20 High Mileage Full Synthetic Motor Oil, Prevents Leaks, 1 Quart (Part No. 15017)
How many quarts of oil does a 2010 Dodge Caliber need?
4.5 quarts
How much oil does a 2010 Dodge Caliber need? The 2.0L inline engine in the 2010 Dodge Caliber typically requires around 4.3–4.5 quarts of oil with filter change—your technician will top up to the correct level and run a post-service check.
What are common problems with the 2010 caliber?
Top 2010 Dodge Caliber Problems
- No start or no crank due to theft system wireless control module.
- Water Leak From Sun Roof Drain Tubes.
- Blown struts.
- Excess drain on battery due to faulty radio.
- Dodge Caliber electrical issues including corroded fuse box, malfunctioning lights, stalling, and fr...
What kind of oil does a 2010 Dodge take?
Takes six quarts of 10W30.