Typically, replacing the ABS module on a Chevy Silverado costs roughly $600 to $1,800, depending on the model year, the part you choose (OEM vs remanufactured vs aftermarket), and local labor rates.
What affects the cost
Several factors drive the total price, including which component is being replaced, the part source, and how much labor is required. The Silverado’s ABS system can be replaced as either a control module or as the entire pump assembly, and options vary in price and complexity.
Parts options
Below are the common parts options you may encounter when replacing the ABS module on a Silverado.
- ABS control module only (remanufactured or new OEM). This is the electronic brain of the system and is typically the less expensive path.
- Entire ABS pump assembly (module plus hydraulic pump). This is more comprehensive and usually pricier.
- Aftermarket/non-OEM ABS modules. These can be cheaper but may have different compatibility or warranty terms.
- Additional related components (sensors, harnesses, or lines) if diagnostics reveal ancillary failures.
Prices vary by supplier and whether you choose remanufactured, new OEM, or aftermarket parts. Be mindful of core charges and any included warranty when comparing quotes.
Labor and installation time
Labor costs depend on how long the technician works on the job and regional shop rates. The following factors commonly influence total labor charges.
- Typical labor time for ABS module or pump replacement: about 1.5 to 3 hours, depending on year and access to the unit.
- Average shop hourly rates: roughly $100 to $180 per hour in many U.S. regions; urban areas can be higher.
- Diagnostic fees may apply if the issue isn’t confirmed as a module failure before replacement.
- Additional tasks that could add cost, such as brake bleeding, sensor replacement, or software reprogramming for certain models.
Labor charges can add significantly to the total, and some shops may bundle diagnostic fees with the repair if you proceed with service.
Cost scenarios
To give you a clearer picture, here are typical total ranges by common replacement paths. These figures exclude tax, shop fees, any core charges, and potential wheel-area work.
- Replace ABS control module only (remanufactured): parts $200–$700; labor $150–$300; total ≈ $350–$1,000.
- Replace ABS control module only (new OEM): parts $600–$1,100; labor $150–$300; total ≈ $750–$1,400.
- Replace entire ABS pump assembly (remanufactured): parts $600–$1,000; labor $200–$400; total ≈ $800–$1,400.
- Replace entire ABS pump assembly (new OEM): parts $1,000–$2,000; labor $250–$450; total ≈ $1,250–$2,450.
The ranges above reflect common market prices and can vary by year, model variant (e.g., Silverado 1500 vs. HD), and locality. Always confirm what is included in a quote (diagnostics, core charges, warranty terms) before authorizing work.
Getting precise quotes
Because costs vary widely, it’s best to obtain several written estimates from reputable shops or Chevrolet dealers. When requesting quotes, share your vehicle’s year, trim, symptoms (ABS warning light, speed sensor messages, or braking issues), and whether you want OEM vs remanufactured parts. Ask about warranty coverage on the replaced part and whether software reprogramming is required.
Summary
Replacing the ABS module on a Chevy Silverado is a repair with a broad price range driven by the choice of part and labor costs. Expect roughly $600 to $1,800 in total, depending on whether you replace just the control module or the full pump assembly, and whether you select remanufactured or OEM components. Always compare quotes that itemize parts, labor, core charges, and warranties to choose the best value for your vehicle.