In the United States, replacing a wheel bearing (hub assembly) on a 2014 Honda Pilot typically costs about $300 to $600 per wheel, including parts and labor. If you need both sides done at the same time, budget roughly $600 to $1,200.
Costs vary with factors like whether you replace a single hub or both, the choice of aftermarket vs OEM parts, local labor rates, and whether additional components such as ABS sensors, tone rings, axle seals, or brake parts are replaced in the same job. The following sections break down the typical price ranges and how to plan for the repair.
Cost breakdown
The price you receive from a shop usually comes from three broad components: parts, labor, and any extras that come up during the job.
- Parts (hub assembly): Expect about $100–$350 for aftermarket hubs per wheel, or $250–$600 for OEM/dealer parts per wheel. Replacing just the hub bearings vs the entire hub assembly can influence the cost, with hub assemblies being the common choice for Honda Pilots of this era.
- Labor: Most repairs take about 1.5–3 hours per wheel. At typical shop rates of $75–$150 per hour, labor per wheel runs roughly $112–$450.
- Extras: ABS sensor or tone-ring replacement, axle shaft seal, rotor/brake pad wear, or a wheel alignment after replacement. These can add $20–$300 or more depending on what needs to be done.
In practice, many consumers report paying around $350–$500 per wheel when replacing a single hub assembly on a 2014 Pilot, with two-wheel replacements often landing in the $700–$1,000 range. Regional differences and shop policies can shift these numbers higher or lower.
Front vs. rear hub replacements
On a 2014 Honda Pilot, wheel bearing replacement can involve front or rear hub assemblies. The front hubs typically involve drive components and ABS sensors, which can push the price upward. Rear hubs are generally similar in complexity but may cost less in some markets, depending on the exact part design and availability.
When to replace one hub vs two
Most repairs are done per wheel, but if both sides show wear or you hear noise on both sides, it’s common to replace both to restore even handling and prevent repeat labor charges.
- Single-wheel replacement: common when only one wheel exhibits bearing noise or play.
- Dual-wheel replacement: often chosen when both sides are worn or when the vehicle is being serviced for other maintenance, which can save on overall labor time.
Whether you replace one or both hubs, the overall cost will reflect the same drivers: parts choice, labor rate, and any additional work required to complete the job safely.
Saving money and choosing a shop
To manage costs without compromising safety, consider these steps before proceeding with a wheel bearing replacement.
- Get multiple quotes from independent shops and compare parts choices (OEM vs aftermarket hub assemblies).
- Ask whether the quote includes the ABS sensor replacement and wheel alignment.
- Request a pre-service diagnostic to confirm the bearing issue and avoid unnecessary work.
- Inquire about performing the job on both sides in a single visit to save on labor time if both sides are worn.
Budgeting for maintenance also means considering potential follow-up costs, such as re-tightened wheel lugs, rotor resurfacing or replacement, and alignment checks after hub replacement.
Summary
Replacing a wheel bearing on a 2014 Honda Pilot typically runs about $300–$600 per wheel in the United States, influenced by parts choice, labor rates, and whether it’s a single or dual-wheel job. Front-wheel bearing replacements tend to be pricier due to drive components and ABS hardware, while rear replacements can be slightly less costly. Always obtain multiple quotes, verify inclusions, and plan for possible extras like axle seals and wheel alignment. With careful comparison shopping, you can budget around $600–$1,200 to replace both front and rear hubs on a two-hub job, depending on your area and the shop you choose.
What are the common problems of a 2014 Honda Pilot?
Top 2014 Honda Pilot Problems
- Warped Front Brake Rotors May Cause Vibration When Braking.
- Noise and Judder on Turns Due to Differential Fluid Breakdown.
- Check Engine Light for Running Rough and Difficulty Starting.
- Engine Idle Speed is Erratic or Engine Stalls.
- Check Engine and D4 Lights Flashing.
What is the cost to have a wheel bearing replaced?
Wheel Bearing Replacement Pricing
| Service type | Typical cost range (per wheel) |
|---|---|
| Front wheel bearing replacement | $150 to $300 |
| Hub-style front bearing (additional) | $100 to $200 |
| Rear wheel bearing replacement | $200 to $500 |
| Professional shop (typical car) | $250 to $500 |
How much does it cost to replace a timing belt on a 2014 Honda Pilot?
Shopping around to get a few quotes is your best bet to get the best deal, but you can expect to pay anywhere from $409 to $919 (including parts and labor).
What are the signs of an overloaded wheel bearing?
Wheel Bearing: How Do I Know if I Need a Replacement?
- Wheel Bearing Quick Facts.
- Humming Noise.
- Squealing or Growling Sound.
- Clicking or Popping Sound.
- Uneven Tire Wear.
- Wheel Wobble.
- ABS or Traction Control Light.
- Vehicle Pulls to One Side.