Brakes for a 2014 Chevy Silverado typically run a few hundred dollars per axle for pads and rotors, with higher totals if calipers or premium components are involved. The exact price depends on whether you replace pads only, add rotors, or also replace worn calipers or sensors, and whether the rear brakes are discs or drums.
The price landscape for this model year varies by region, shop, and parts choice. This article breaks down typical costs by component and by brake setup, and notes extra charges that can appear, such as a brake fluid flush or sensor replacements.
Parts cost overview
Costs depend on the specific parts you choose and the brake configuration on your Silverado. The following ranges cover common aftermarket parts and configurations.
Front brakes (disc)
Typical prices for common front brake parts when replacing pads and rotors.
- Brake pads (per axle): $30–$150
- Rotors (per rotor): $25–$120 (two rotors: $50–$240)
- Calipers (per unit): $60–$300
- Brake hardware and wear sensors: $10–$50
Conclusion: Front brakes usually drive the bulk of a brake job because both pads and rotors are typically replaced together, especially on older vehicles.
Rear brakes (disc or drum)
Prices vary based on rear brake configuration. Disc brakes are priced similarly to the front; drum brakes hinge on shoes, drums, and wheel cylinders.
- Brake pads/shoes (rear, if discs or shoes on discs): $25–$70
- Drums (per drum, rear drums): $20–$60
- Wheel cylinders (rear): $20–$60
- Hardware kits for rear brakes: $10–$40
Conclusion: If your Silverado uses rear drums instead of discs, the parts mix changes, but the total costs can still be substantial depending on hardware and labor time.
Labor costs
Labor time and rates are major components of the final price. The following estimates reflect typical shop rates and time frames.
- Front brakes (pads + rotors): 1.5–3 hours
- Rear brakes (disc or drum): 1–2.5 hours
- Average labor rate: $75–$120 per hour (varies by region and shop)
Conclusion: Labor often equals or exceeds parts costs, especially when rotors are replaced on both axles or calipers are involved. A full vehicle brake job can run several hundred dollars per axle depending on choices.
Putting it together: typical total ranges
For a standard, two-axle brake job with pads and rotors on both front and rear discs, expect roughly $200–$450 per axle for parts and another $120–$360 per axle for labor, depending on parts quality and regional labor rates. If rear brakes are drums, the parts mix changes, but the total can remain in a similar ballpark, with variations based on labor time and component choices. Premium rotors, performance brake pads, or caliper replacement can push totals higher.
Summary
Brake replacement costs for a 2014 Chevy Silverado vary widely but cluster in the hundreds per axle for a standard pads-and-rotors job, with higher totals if calipers, premium parts, or rear drum setups are involved. Always obtain a written estimate that itemizes pads, rotors or shoes, calipers (if needed), and labor, and confirm whether additional services like a brake fluid flush or sensor replacement are included.