About 4.8 quarts (roughly 4.5 liters) of engine oil are needed for a full oil change on the 2015 Nissan Rogue with a 2.5 L engine, including a new filter.
In practice, the Rogue’s oil capacity is specified for a complete oil change with the filter, and the exact amount can vary slightly if you’re topping off or if your engine requires a different filter size. The vehicle typically calls for 0W-20 full-synthetic oil, and maintenance intervals depend on driving conditions and oil type. Always verify with the owner’s manual or a Nissan service bulletin for your region.
Oil capacity and grade
The following details apply to the 2015 Rogue's 2.5 L engine when performing a standard oil change with filter replacement.
- Oil capacity (with filter): 4.8 quarts (approximately 4.5 liters).
- Recommended viscosity: 0W-20 full-synthetic oil in most markets; 5W-20 may be acceptable in some climates—check your manual for regional guidance.
- Common replacement interval: typically 5,000 miles (8,000 km) under normal driving, up to 7,500 miles (12,000 km) when using synthetic oil and driving conditions are favorable; follow the schedule in the owner’s manual.
Understanding these figures helps ensure proper lubrication and engine longevity. Always confirm the exact specification for your vehicle’s VIN and region, as there can be small variations in service data.
Maintenance planning and best practices
Before performing an oil change or planning maintenance, keep these steps in mind to ensure accuracy and safety.
- Warm up the engine briefly and turn off the vehicle before draining oil to improve drainage.
- Place the vehicle on a level surface and use a proper drain pan to collect old oil.
- Remove the drain plug and allow all oil to drain fully, then replace the drain plug with a new crush washer if needed.
- Replace the oil filter with a new Nissan-approved filter designed for the 2.5 L engine.
- Pour in the recommended amount of new oil (4.8 quarts with filter) and check for level on the dipstick after a few minutes of settling.
- Run the engine, turn it off, recheck the level, and top off in small increments if necessary.
- Reset any maintenance or oil-change warning indicators if your vehicle uses them.
Following these steps helps ensure you reach the correct fill level and maintain engine protection. If you’re uncertain or lack the proper tools, consult a qualified technician.
Notes and quick references
For the most precise specification, consult the 2015 Rogue owner’s manual or contact a Nissan dealer, as regional service data may vary. Use a high-quality 0W-20 full-synthetic oil unless otherwise specified by Nissan for your market, and adhere to the recommended maintenance schedule to avoid voiding warranties.
Summary
The 2015 Nissan Rogue 2.5 L typically requires about 4.8 quarts of oil with a new filter when performing an oil change, using 0W-20 full-synthetic oil in most regions. Verify exact figures for your VIN and driving conditions, and follow the official maintenance intervals to keep the engine running smoothly.