Approximately 5 quarts (4.7 liters) of engine oil are needed for a full oil change with the filter on a 2018 Jeep Compass 2.4 L. If you skip replacing the filter, the total capacity is about 4.2 quarts (4.0 liters).
This article explains the official capacity figures for the 2.4 L Tigershark engine used in that model, what they mean for maintenance, and how to ensure you use the correct oil and procedure.
Oil capacity for the 2.4 L Tigershark engine
These values reflect a standard oil-change scenario for the 2018 Compass equipped with the 2.4 L engine, including a new filter. They help determine how much oil you should have on hand during service.
With filter vs without filter
- With engine oil filter: 5 quarts (4.7 liters)
- Without engine oil filter: 4.2 quarts (4.0 liters)
Note that the above figures refer to the engine’s capacity including the oil in the filter. When topping off between changes, you may only need a portion of these amounts depending on dipstick readings and service history.
For practical planning, the 5-quart figure is the standard reference for a full oil change with a new filter. Always verify your exact vehicle’s specs with the owner’s manual or your local dealership, as VIN-specific variations can occur.
Maintenance context and guidance
Oil capacity is one piece of the maintenance puzzle. Always use the recommended viscosity and specification for the 2.4 L Tigershark engine, and follow the vehicle’s service interval guidelines. The owner's manual or a Jeep dealership can confirm the exact oil grade (often a low-viscosity synthetic such as 5W-20 or 0W-20, depending on climate) and the correct procedure for your model year.
Summary
In short, the 2018 Jeep Compass 2.4 L typically takes about 5 quarts of engine oil for a full change with a new filter (4.7 L). If the filter is not replaced, the capacity is around 4.2 quarts (4.0 L). Always consult the owner's manual or dealer documentation for your exact VIN and preferred oil specification to ensure accurate service.