The 2018 Ford Escape with a 2.5-liter engine requires about 4.8 quarts of engine oil when performing a full change with a new filter.
For readers planning maintenance, the 2.5 L Duratec engine’s oil capacity is specified as 4.8 quarts (with filter). The recommended viscosity is SAE 5W-20, and most owners should plan oil changes every 5,000 to 7,500 miles depending on driving conditions. Always verify the final level on the dipstick after adding oil.
Oil capacity and specifications
Key facts to keep in mind about the 2018 Escape's oil capacity are listed below.
- Engine oil capacity: 4.8 quarts (with filter) for the 2018 Escape 2.5L Duratec engine.
- Recommended oil grade: SAE 5W-20 (synthetic blend or full synthetic) as per Ford specifications.
These figures apply to standard oil changes using a new filter. If you substitute a different filter or nonstandard oil, the exact quantity needed may vary slightly; always confirm with the owner's manual or dealer.
Oil change tips and steps
To help you perform an oil change, follow these practical steps and guidelines.
- Gather supplies: 4.8 quarts of oil, a new oil filter, a drain pan, a funnel, and basic hand tools.
- Warm up the engine for a few minutes to loosen oil, then turn off and safely raise the vehicle if needed.
- Drain old oil from the pan and replace the old filter to ensure proper filtration.
- Reinstall the drain plug, then add liquid gradually, starting with about 4.0 quarts and checking the level with the dipstick.
- Run the engine, recheck for leaks, and top off to the full mark if necessary, ensuring the level reads within the recommended range on the dipstick.
Always dispose of used oil and filters at a proper recycling facility, and reset the oil-change reminder if equipped.
Summary
In short, a 2018 Ford Escape with a 2.5 L engine takes about 4.8 quarts of engine oil during a standard oil change with a new filter. Use 5W-20 oil and plan maintenance intervals around 5,000 to 7,500 miles, depending on driving conditions. Properly measure and verify the final oil level with the dipstick for a safe, properly lubricated engine.