About 6 quarts of engine oil are needed for a full change on the 2017 X3 with the 2.0 L engine.
The 2017 BMW X3 uses a 2.0-liter engine in many markets (commonly the turbocharged N20 petrol engine for xDrive28i models). Oil capacity figures can vary slightly depending on the exact engine variant and whether the oil filter is replaced during the service. This article outlines the standard capacity and practical notes for this model year.
Oil capacity specifics for the 2017 X3 2.0 L
Note: The following figure reflects a standard oil change that includes replacing the oil filter. Engine variants and regional specifications can affect the exact amount, so always verify with your manual or a dealer for VIN-specific guidance.
Key figures at a glance:
- Oil capacity with filter change: 6 quarts (approximately 5.7 liters)
When performing an oil change, it is standard to replace the oil filter and fill to the full capacity, then check the level with the dipstick to ensure it sits between the minimum and maximum marks. If you’re unsure about the exact specification for your vehicle variant or market, consult the owner’s manual or a BMW service advisor.
Variant considerations
The 2017 X3 offered multiple 2.0 L powertrains, including petrol (N20) and diesel options in some markets. The 6-quart figure cited above primarily applies to the petrol 2.0 L turbo engine typical of the xDrive28i models. Always confirm the exact capacity for your specific engine and VIN using the official manual or BMW’s online resources.
Summary
For a 2017 BMW X3 with the 2.0 L engine, plan on about 6 quarts of engine oil for a full change, including the oil filter. Confirm the precise figure for your exact engine variant and market by consulting the owner’s manual or a BMW service professional, especially if you have a diesel variant or a non-standard maintenance setup.