How do you reset the tire pressure light on a Honda Pilot?

To reset the tire pressure light on a Honda Pilot, inflate all four tires to the manufacturer’s recommended cold pressures listed on the driver’s door jamb sticker and drive the vehicle so the system can recalibrate. If the light remains on, you may need to reset the TPMS manually using a dedicated button or the vehicle’s settings, depending on your model year.

Understanding the TPMS and when it resets

The Tire Pressure Monitoring System (TPMS) monitors each tire’s pressure and alerts you when any tire is below the recommended level. After you correct low pressures, the system may reset automatically, or you may need to initiate a manual calibration depending on your Pilot’s year and trim. Always start by verifying the correct cold pressures on the door jamb sticker or in the owner’s manual.

Automatic reset: inflate and drive

Before proceeding with the automatic reset, ensure all tires are inflated to the recommended cold pressures. If the system is capable of an automatic recalibration, simply driving the car after inflation will typically clear the warning.

1. Check all four tires and inflate them to the recommended cold pressures listed on the driver’s door jamb sticker or in the owner’s manual. Do not rely on “hot” readings after the car has been driven recently.


2. Turn the ignition to ON with the engine off and confirm tire pressures are correct; adjust as needed.


3. Drive the Pilot at a normal, steady speed for about 10 to 15 minutes (typically on highways or arterial roads) so the TPMS can recalibrate.


4. Return to a stop and check whether the TPMS light has turned off. If it goes out, the system is calibrated. If it remains on, proceed to the manual reset options below.

Note: If you see the light again after calibration, there may be a sensor issue, a slow leak, or another fault in the TPMS that requires service.

Manual reset options

Some model years offer a manual TPMS reset/calibration option. The exact method varies by year and trim, so consult your owner’s manual for the precise steps. The two common approaches are described here.

Physical button method (where available)

Use this method if your Pilot has a dedicated TPMS/SET button near the left side of the dash or under the steering column.

1. With the ignition ON and the engine OFF, locate the TPMS or SET button.


2. Press and hold the button until the TPMS indicator blinks or a confirmation message appears (often a blink sequence on the dash).


3. Release the button and drive the vehicle for 10–15 minutes at steady speeds to complete calibration.

Concluding note: A successful manual reset requires all tires to be inflated to the correct pressures beforehand.

Menu-driven method (infotainment/driver information display)

For newer models with TPMS calibration in the vehicle settings, use the dashboard display to calibrate the system.

1. Turn the ignition to ON and access the driver information display or infotainment menu.


2. Navigate to Settings or Vehicle Settings > TPMS Calibration (or Tire Pressure Monitor) > Calibrate.


3. Confirm and then drive for 10–20 minutes at highway speeds to complete calibration.

Final tip: After using the menu-driven method, the light should turn off once calibration is complete and valid pressure readings are maintained.

What to do if the light stays on

If the TPMS light remains on after inflation and calibration attempts, there may be a sensor fault (such as a dead sensor battery or damaged sensor), a TPMS receiver issue, or a recent tire service not properly reprogrammed. Have a certified Honda technician inspect the system, reprogram sensors if needed, and verify there are no slow leaks in any tire.

Quick reference checklist

Before attempting a reset, use this quick checklist to ensure accuracy. The steps apply to most Honda Pilot models with standard four TPMS sensors.

• Confirm all four tires are at the recommended cold pressures (door jamb sticker).


• Check for visible tire damage, punctures, or slow leaks.


• Avoid inflating tires with sealant or temporary repairs that could affect TPMS readings.


• Refer to the owner’s manual for your model year’s exact TPMS reset procedure if needed.

If you’re unsure about which method applies to your Pilot, consult the owner’s manual or contact a Honda service provider for model-specific instructions.

Summary