The location depends on your Civic’s year and trim, and not all models use a dedicated reset button. In many Civics, you’ll find a TPMS/SET/RESET control under the dash near the steering column, inside the glove box, or you may reset the system through the instrument cluster or infotainment menu.
This guide explains where to look, how to reset the system, and what to do if you can’t locate a physical button.
Understanding TPMS and why you might need to reset it
The tire pressure monitoring system (TPMS) keeps track of your tire pressures and alerts you if any tire drops below the recommended level. A reset is typically needed after inflating tires to spec, after rotating tires, or after replacing wheels or sensors. If the light stays on after a reset attempt, you may have a sensor issue or a tire leak that needs attention.
Where to look for the reset control
Before you search, note that some Civics use a physical button, while others rely on an on-screen reset option. The following locations are commonly reported by owners across generations.
- Under the left side of the instrument panel, near the steering column, where a small button labeled TPMS, SET, or RESET may live.
- Inside the glove box or near the glove box opening, sometimes tucked behind a panel or label.
- On the driver's door panel or near the light switch cluster, especially on earlier models.
- In the center console area or near the gear shifter, depending on trim level.
The exact spot can vary, so if you don’t see a labeled button, check the owner’s manual for your specific model year and trim or contact your Honda dealer.
Reset procedures for Civics with a dedicated button
If your Civic has a dedicated TPMS/SET/RESET button, follow these steps. Prepare by ensuring all tires are inflated to the recommended pressures first.
- Inflate all tires to the recommended cold tire pressures shown on the door jamb sticker.
- Turn the ignition to ON (engine off) and locate the TPMS RESET button.
- Press and hold the TPMS/SET/RESET button until the TPMS light on the dash blinks slowly, then release it. On some models, the light may flash three times and then stay off.
- Drive the vehicle at speeds above 30–50 mph (50–80 km/h) for about 10 minutes to relearn the sensors.
If you follow these steps and the TPMS light remains on, you may have a faulty sensor or a tire leak. A visit to a tire shop or Honda service is advised for a live relearn with a scan tool.
Some Civics with a dedicated button also offer an on-screen prompt. If your model shows a TPMS reset option in the instrument cluster or infotainment system menus, follow the on-screen instructions to complete the relearn.
Reset via instrument cluster or settings (no dedicated button)
Newer or higher-trim Civics may let you reset TPMS through the vehicle’s settings instead of a physical button. Use these general steps, noting that wording can vary by year and software version.
- Ensure all tires are inflated to the recommended pressures, then start the car or turn the ignition to ON (engine off).
- Navigate to the vehicle’s TPMS or Tire Pressure monitoring section in the instrument cluster or infotainment menu (for example: Settings > Vehicle > TPMS, or Tire Pressure).
- Select Reset or Calibration, then confirm. The indicator light may blink or extinguish as the system relearns the sensors.
- Drive as directed by the on-screen prompts (commonly at 30–50 mph for 10–15 minutes) to complete the relearn.
If your system doesn’t show a reset option, or the light doesn’t clear after a relearn, you may need a professional scan tool to complete the calibration.
What to do if you can’t locate a reset button or option
If you still can’t find a reset button or an on-screen reset option, try these steps and precautions:
- Double-check tire pressures when the tires are cold and inflate to the door-jamb specification.
- Rotate tires back to their original positions if you recently rotated them, then attempt a standard relearn again.
- Inspect tires for leaks, punctures, or damaged sensors; a faulty sensor often triggers an ongoing TPMS warning.
- Consult the owner’s manual for your exact model year and trim or contact a Honda dealer or qualified tire shop for a sensor relearn using proper equipment.
In some cases, a persistent TPMS warning after these steps requires sensor replacement or reprogramming by a trained technician.
Summary
The TPMS reset process on a Honda Civic varies by model year and trim. Some Civics have a dedicated TPMS/SET/RESET button located under the dash near the steering column or in the glove box, while others rely on a menu-driven relearn in the instrument cluster or infotainment system. Always start by inflating tires to the recommended pressure, then follow the appropriate reset method for your vehicle. If you’re unsure, consult the owner’s manual for your exact model or visit a Honda service center for help with a proper TPMS relearn.
Where is the manual TPMS reset button?
Process will begin if there's no button the procedure is done with the display audio. Begin by pressing the home. Button then touch settings touch vehicle next and then TPMS calibration.
Where is the TPMS reset button on a Honda Civic?
If your Honda is equipped with a TPMS button, you'll find it to the left of the steering wheel.
Why is my TPMS light on but tires are fine on my Honda?
One of the most common reasons for a TPMS light staying on despite the tires being properly inflated is a sensor malfunction. TPMS sensors are typically located inside the tire and can wear out or become damaged over time, particularly if you've hit a curb, driven through a pothole, or been off-road.
How do I turn off the TPMS light on my Honda?
Shut your vehicle off, then, turn the key to the “On” position without fully starting the car. Press and hold the TPMS reset button until the tire pressure light blinks three times, then release it.