The tire pressure reset button (TPMS reset) on most Honda Pilot models sits in the driver's side footwell, to the left of the steering column, and is usually labeled “TPMS” or shown with a tire icon. After inflating all tires to the recommended cold pressures, you press and hold the button to relearn the system. If your year’s Pilot doesn’t have a dedicated button, the TPMS may relearn automatically after driving with corrected pressures.
Location and procedure can vary by model year and trim level. Some Pilots require a simple drive after correcting tire pressures, while others use a specific ignition-on sequence with a TPMS button. Always consult your owner’s manual for the exact steps for your vehicle.
Common locations inside the cabin
Several Pilot generations place the TPMS control in the driver’s vicinity under the dash. Here are the most typical spots you should check:
- Left side of the steering column, in the driver’s footwell area, near the hood release lever.
- In a few older or less common trims, a TPMS button may be located near the fuse/relay box on the driver's side under the dash.
If you don’t see a TPMS button in these areas, your model may relearn automatically or use a different procedure. Always verify with the owner’s manual or dealer if you’re unsure.
Resetting the TPMS: step-by-step procedure
Before attempting a reset, ensure all tires are inflated to the recommended cold pressures noted on the door jamb sticker or in the owner’s manual. The steps below describe the typical process for models that have a TPMS reset switch.
- Inflate all tires to the recommended cold pressures. Do not rely on recently driven pressures.
- Turn the ignition to ON (engine off) or RUN, depending on your model’s requirement.
- Locate the TPMS reset button in the driver’s footwell area and press/hold it until the TPMS indicator on the dash flashes once or twice, or you hear a confirmation chime. Release when you see the confirmation.
- Drive the vehicle for about 10 minutes at road speeds (roughly 30–50 mph) to relearn the sensors and complete the reset.
Note that some trims may require a slightly different sequence (for example, holding the button for longer, or performing the reset with the ignition in a specific position). If the warning light remains after the drive, repeat the steps or consult the manual for model-specific instructions.
No dedicated reset button? What to do
Not all Honda Pilot years and trims include a physical TPMS reset button. In those cases, the system typically relearns automatically once the tires are correctly inflated and you drive the vehicle for enough miles at highway speeds. If the light stays on after driving, you may need to check each tire’s pressure again or have the system inspected for sensor faults.
No dedicated button on some trims
For Pilots without a reset switch, rely on corrected tire pressures and a normal driving cycle to relearn the sensors. If the light persists after a reasonable driving period, the TPMS sensors or receiver may require service.
If you’ve inflated to spec and followed any available reset procedure but the TPMS light remains illuminated, it’s wise to have the system inspected. A dealer or tire shop can verify sensor health and reprogram the system if needed.
Summary
In most Honda Pilot models, the TPMS reset button lives in the driver’s footwell, left of the steering column, and is labeled TPMS. After correcting tire pressures, hold the button (or follow the year-specific sequence) and then drive to complete the relearn. Some Pilots rely on automatic relearn through normal driving, and a few trims don’t have a dedicated reset button at all. When in doubt, consult the owner’s manual for your exact year and trim, or contact a Honda service professional for guidance.