The 2016 Honda Accord with a 2.4-liter engine takes about 4.5 quarts (roughly 4.3 liters) of engine oil when performing a standard oil change with the filter installed. The typical recommended oil grade for this engine is 0W-20 synthetic, though in some regions 5W-20 may also be acceptable; always verify with the owner's manual or your dealer for your market.
Understanding the exact capacity helps ensure you don’t underfill or overfill the engine, which can affect lubrication and performance. The official specification is published by Honda and is generally consistent across model years, but regional differences and service practices can lead to small variations. The following sections break down the official figures and practical how-to guidance for this 2.4L four-cylinder Accord.
Oil capacity and specifications
Here are the key figures you should know before you start a change.
- Total engine oil capacity with the filter installed: 4.5 quarts (about 4.3 liters).
- Recommended oil type: Synthetic 0W-20 is standard for this engine; 5W-20 may be acceptable in some regions per local guidelines.
When performing a change, aim to bring the engine to the correct level after running a few minutes and then rechecking with the dipstick. If you replace the filter, expect to add roughly the full 4.5 quarts and then adjust as needed to hit the proper dipstick mark.
DIY oil change steps for the 2016 Accord 2.4L
Following a standard DIY routine helps ensure a clean, accurate change. The steps below outline a typical process; always follow the vehicle’s manual for any model-specific torque values or procedures.
- Warm up the engine briefly, then turn it off and secure the vehicle on a level surface.
- Raise the car safely and place a drain pan beneath the engine oil drain plug.
- Remove the drain plug and allow used oil to fully drain from the pan.
- Remove and replace the oil filter with a new one, ensuring the seal is clean and properly seated.
- Reinstall the drain plug and tighten to the manufacturer’s specification.
- Pour in the recommended amount of new oil (about 4.5 quarts for a complete fill with the filter).
- Start the engine and let it run for a couple of minutes, then turn it off and wait a few minutes for the oil to settle.
- Check the oil level with the dipstick and add more oil if necessary to reach the proper mark.
- Dispose of the used oil and filter according to local environmental regulations.
For torque specs and any model-specific nuances, consult the Honda service manual or contact a dealer. Proper disposal of old oil is essential to environmental responsibility.
Summary
The 2016 Honda Accord 2.4L uses about 4.5 quarts (4.3 liters) of engine oil when you change the oil with the filter. The usual recommendation is synthetic 0W-20, with 5W-20 as a regional alternative per local guidelines. Always verify exact figures in the owner's manual for your vehicle’s market, perform a careful fill-and-check process, and follow proper disposal practices for used oil.