The oil filter on a 2023 Ford F-150 is located in a remote cartridge housing mounted to the front of the engine, and it is typically reachable from underneath the truck after removing the underbody shield. Exact placement can vary by engine and trim.
In practice, Ford uses a cartridge-style oil filter in a front-mounted housing rather than a traditional spin-on filter in many 2023 F-150 configurations. The precise location depends on the engine option (for example, 3.5L EcoBoost, 5.0L V8, 2.7L EcoBoost, or hybrid variants) and may require removing protective panels or shields to access the filter.
Engine-specific oil filter locations
The following outlines typical locations for common 2023 F-150 engines. If your engine differs or you’re unsure, consult the owner’s manual or a Ford service guide for your VIN.
3.5L EcoBoost V6
Oil filter location for the 3.5L EcoBoost is a remote cartridge in a housing mounted on the front, passenger-side portion of the engine. Access is usually gained from underneath the vehicle with the front undertray removed.
- Remote cartridge oil filter housed in a front-facing unit on the passenger side.
Note: Some trims may require removing additional underbody panels to reach the housing.
5.0L V8 (Coyote)
The 5.0L V8 uses a cartridge-style filter located in a housing at the front of the engine, near the timing cover. Access is typically from below the vehicle and may require shield/underbody panel removal.
- Cartridge-style oil filter in a front housing near the timing cover.
Always verify the exact access point for your production date and trim level.
2.7L EcoBoost
The 2.7L EcoBoost also uses a cartridge-style filter in a front-side housing. Access is usually from underneath the truck after removing underbody shields.
- Front-side cartridge filter housing accessible from below.
Location can vary slightly by build date; refer to the manual for specifics.
Hybrid and other variants
Hybrid and some other 2023 F-150 configurations commonly use a similar front-mounted cartridge housing, though exact positioning can differ by model year and production batch. Always check the manual for your exact VIN.
- Front-mounted cartridge housing; access from beneath with shields as needed.
If you’re unsure of the exact location, a quick visual search in the engine bay for a removable cartridge filter housing near the front of the engine is a good start, and a dealer or service manual can confirm the precise spot.
How to identify and access the oil filter safely
Knowing the general area is helpful, but proper access and safety are crucial when servicing the oil filter on a modern F-150. The steps below outline a safe approach to locating and preparing for a filter change.
- Park on a level surface, apply the parking brake, and place wheel chocks behind the rear tires.
- Open the hood and inspect the underside of the front of the engine bay to locate the oil filter housing; remove any splash shields or undertray if required.
- Place a drain pan beneath the oil pan, loosen the filter housing cap or remove the housing to access the cartridge, and carefully remove the old filter.
- Install a new cartridge and O-ring as specified by Ford, reassemble the housing, and torque to the recommended specification.
- Refill with the correct engine oil grade and capacity, start the engine, check for leaks, and recheck the oil level after a few minutes of operation.
Always dispose of used oil and the old filter properly, and use the oil specification recommended for your engine variant.
Summary
For the 2023 Ford F-150, the oil filter is typically a cartridge-type unit housed in a front-facing housing on the engine, most often on the passenger side, and accessible from underneath with underbody shields removed. Exact placement varies by engine (3.5L EcoBoost, 5.0L V8, 2.7L EcoBoost, or hybrid) and production date, so consult your owner's manual or a Ford service guide for your specific VIN to confirm the location and replacement procedure.