The oil filter on a 2016 Toyota Camry is located on the lower side of the engine block, tucked in a cartridge-style housing on the passenger side near the oil pan.
For 2016 Camry models, Toyota offered two engines: a 2.5-liter four-cylinder (2AR‑FE) and a 3.5-liter V6 (2GR‑FE). Both use a cartridge-type oil filter mounted to the engine block. Access is typically from underneath the vehicle after removing the front undertray or splash shield; some trims allow top access after removing the engine cover. The exact orientation can vary slightly by model, but the filter remains in a canister on the lower side of the engine.
Engine-specific oil filter location
2.5L four-cylinder (2AR-FE)
In this engine, the cartridge oil filter sits inside a round canister mounted on the passenger-side of the engine block, just above the oil pan. Access is usually from underneath the car after removing the front splash shield; on some setups you may reach it from above with the hood open and the engine cover removed.
3.5L V6 (2GR-FE)
The V6 also uses a cartridge-style filter housed in a canister located on the lower side of the engine, commonly on the passenger-side near the front of the block. It is generally accessible from beneath the vehicle once the splash shield is removed, with rare top-access variations depending on trim.
Access and replacement steps
To locate and access the filter, follow these preparatory steps.
- Park on a flat surface, engage the parking brake, and place wheel chocks behind the rear wheels.
- Loosen and remove the front undercarriage splash shield to expose the underside of the engine.
- Look for a cylindrical oil filter canister mounted to the engine block on the passenger side, near the oil pan.
- Use the appropriate oil filter cap tool or wrench to loosen and remove the cap, replace the cartridge filter inside, then reseal and torque per service specs.
- Reinstall the splash shield, lower the car, and refill with the correct engine oil to the proper level; check for leaks after startup.
Conclusion: Replacing the oil filter on a 2016 Camry is a routine maintenance task that is typically performed from beneath the vehicle, though some setups may allow top-side access. Always follow Toyota’s specified torque and replacement guidelines and consult the owner’s manual or a qualified tech if you’re unsure.
Summary
The 2016 Toyota Camry stock filter lives in a cartridge-style canister on the lower side of the engine, usually on the passenger side near the oil pan. Access generally requires removing the front splash shield and working from underneath the car, with similar placement across the 2.5L four-cylinder and 3.5L V6 engines. Always use the proper tools and refer to the service manual for exact torque specs and cartridge details.
Where is the oil filter on a Toyota Camry 2016?
And there it comes. Now it drains the oil filter. It's done draining just pull it out now we're going to remove the oil filter 1/2 in drive ratchet 64 mm oil filter.
Where is the oil filter located in a Toyota Camry?
All. So they forced me to buy my own special tool that couples over. This. Okay guys on this oil filter is or this cap. See that little metal tab right. There. That's going to bend.
Which Camry is the fastest?
Toyota Camry TRD
The Fastest Camry Ever Sold
The Toyota Camry TRD was powered by a 3.5-liter V6 making 301 hp and 267 lb-ft of torque. This caused the Camry TRD to launch to 60 mph in less than six seconds, or 5.8 to be exact. To put that into perspective, that's a quicker 0-60 time than Toyota's own dedicated sports car, the GR86.
Where is the engine oil filter located?
The oil filter is usually located beside the oil pan or under the hood of your vehicle near the engine. Place the collection pan under the filter. You can use a filter wrench to help remove.