The oil filter on a 2016 Honda Odyssey with the 3.5L V6 is located on the passenger side of the engine block, toward the rear of the engine, and is typically accessed from underneath the vehicle—often via the right-front wheel well after removing the splash shield.
Where to look in the engine bay
The Odyssey uses a cartridge-style oil filter housed in a small metal canister attached to the engine block. The exact spot can vary by trim, but you’ll usually find it on the passenger side near the firewall and above the oil pan. If you can’t see it from the top, you may need to lower the vehicle and remove shielding to view the filter housing.
To help you locate it quickly, here are the most common spots and how to recognize them.
- Passenger-side area of the engine block, near the firewall and above the oil pan; look for a cylindrical canister-style housing or a visible cap that seals the filter cartridge inside.
- Behind or behind the right front wheel well; some models tuck the filter behind shielding that must be removed for access.
- In some configurations, the cartridge sits inside a small remote housing mounted to the side of the engine block; the end-cap or housing cover is the point of removal.
If you still cannot locate the filter, check the owner's manual or Honda service literature for your VIN, or ask a professional mechanic for assistance.
How to proceed with a change (overview)
Below is a general sequence for replacing the oil and filter. The exact steps and torque values vary by model year and engine variant; consult the service manual if possible.
- Prepare the vehicle: park on a level surface, apply parking brake, chock wheels, and gather the correct filter cartridge and oil type for your engine.
- Drain the old oil: place a drain pan under the oil pan, remove the drain plug, and allow oil to drain completely.
- Remove and replace the filter: using the appropriate tool, loosen and remove the filter cap or housing, take out the old cartridge, and install a new cartridge or filter according to the factory spec.
- Reassemble and refill: reinstall the housing cap, tighten to the specified torque, replace the drain plug, refill with the correct amount of oil, and check for leaks and proper oil level.
After completion, start the engine, check for leaks, and dispose of used oil and filters according to local regulations.
Summary
For a 2016 Honda Odyssey, locate the oil filter on the passenger side of the engine block, near the firewall and above the oil pan. Access may require looking from underneath or removing under-hood shielding. If in doubt, consult the owner’s manual or a Honda service manual for your exact VIN, and consider professional service for the oil change.