The location of the oil filter on a 2014 Ford Fusion depends on the engine installed. In most configurations, you’ll find a cartridge-style oil filter either mounted in a housing on the engine block or as a remote filter near the front underside of the engine. Some EcoBoost variants route the filter through a front-mounted housing that’s accessible from the wheel well or underneath the car. Always verify with your specific engine’s manual to be certain.
To understand this question in more detail, it’s important to recognize that Ford offered several engines for the 2014 Fusion, including the 2.5L inline-four, the 1.6L EcoBoost, the 2.0L EcoBoost, and the 3.5L V6 in certain trims. Each powertrain uses a slightly different oil-filter arrangement. The following sections outline typical locations by engine type and practical tips for locating the filter on your vehicle.
Engine variants and filter locations
Because the 2014 Fusion used multiple engines, the oil-filter placement varies. The bullets below summarize the common configurations you might encounter.
- 2.5L I4 (base): Cartridge-style filter mounted in a housing on the engine block, typically on the passenger side, and accessible from the top after removing a cover or from underneath with the splash shield removed.
- 1.6L EcoBoost: Remote oil filter mounted near the front of the engine, often behind a protective shield or accessible from the wheel well area.
- 2.0L EcoBoost: Similar to the 1.6L EcoBoost, with a remote-style filter or housing located at the front side of the engine, usually reachable from beneath the vehicle or through the wheel well.
- 3.5L V6: Oil filter located on the front/passenger side of the engine block, near the timing cover, accessible from above with the engine cover removed or from underneath with appropriate access.
Note: Filter designs can vary by market and production batch, and many modern Ford engines use cartridge-style filters that may require removing a plastic engine cover or splash shield to reach the filter housing.
How to locate the oil filter on your 2014 Fusion
If you want to confirm the exact location on your car, use these practical steps to visually locate the filter.
- Prepare the vehicle: park on a level surface, engage the parking brake, and let the engine cool before touching any components.
- Open the hood and inspect the engine bay for a plastic engine cover or shields that may conceal the filter. In many EcoBoost models, you’ll need to remove the cover or shield to access the filter housing.
- Check around the front of the engine block and along the passenger side for a cylindrical filter canister or a housing with a removable cap. Remote filters often sit low near the front underside of the engine bay.
- Look for a metal or plastic housing with hoses attached, or a round canister that resembles a filter housing. If you locate a cap with a square or hex boss, that’s typically the filter housing access point.
- If you still can’t find it, consult the owner’s manual or a official Ford service manual for your exact VIN/engine code, or ask a dealership/mechanic to confirm the precise location for your vehicle.
Once located, follow the proper procedures in the service manual to replace the filter, and always use the correct filter type and oil specification for your engine.
Summary
The oil-filter location on a 2014 Ford Fusion varies by engine: base 2.5L may use a housing on the passenger side of the engine block; EcoBoost variants often employ a remote filter mounted near the front of the engine, accessible from beneath or the wheel well; the 3.5L V6 places the filter near the timing cover. Always verify with your specific engine’s documentation and visually locate the filter by removing any necessary covers or shields. When in doubt, consult a professional to avoid damage during replacement.