The oil filter on the 2010 Ford Fusion Hybrid sits on the underside of the engine, toward the front on the passenger side, inside a filter housing that is accessible from beneath the vehicle.
In this hybrid model, the 2.5-liter four-cylinder engine uses a replaceable filter element inside a canister mounted to the engine block. Servicing it typically requires removing the undercarriage splash shield for enough clearance and access from below.
Locating the oil filter
Use these cues to locate the filter housing on a 2010 Fusion Hybrid:
- The filter assembly is mounted to the bottom of the engine block on the passenger side, near the front of the engine bay.
- Access is gained from beneath the vehicle; you may need to remove the underbody splash shield to reach the housing.
- The filter sits inside a cylindrical canister or cap-type housing; look for a round end-cap or plug that is removed with a filter wrench or socket.
If you cannot locate the filter visually, consult the owner's manual or a factory service manual for your exact configuration, as the orientation can vary slightly by trim or production batch.
Replacing the oil filter
Before you begin, set up a safe workspace and gather the necessary tools and supplies.
- Park on a level surface, apply the parking brake, and raise the car with a jack stands or ramps. Place chocks on the opposite wheels.
- Drain the engine oil by removing the drain plug on the oil pan and allowing used oil to flow into a drain pan.
- Loosen and remove the oil filter housing cap or canister using the appropriate tool, then remove and discard the old filter element.
- Install a new filter element into the housing, ensuring it seats correctly and that any O-rings or seals are in good condition or replaced as needed.
- Reinstall the housing cap or canister and torque to the manufacturer’s specification.
- Refill the engine with the correct amount and grade of oil for the 2.5L engine in the Fusion Hybrid, then replace the filler cap.
- Run the engine briefly, check for leaks, and recheck the oil level with the dipstick; top off as needed.
- Dispose of the used oil and filter at a proper recycling facility.
After completing the replacement, ensure there are no leaks around the filter housing and that the oil level is within the recommended range before driving.
Safety tips and maintenance notes
Always work on a cool engine and support the vehicle securely. If you’re uncertain about the orientation or cannot access the housing safely, consult a professional mechanic or a dealership service department.
Summary
The oil filter on a 2010 Ford Fusion Hybrid is mounted to the bottom of the engine on the passenger-side front area, accessible from underneath with the undercarriage splash shield removed. Replacement involves draining engine oil, removing the filter housing cap, replacing the filter element, resealing the housing, and re-filling with oil. Always follow the vehicle’s service manual for exact torque specs and oil capacity, and dispose of used oil responsibly.