The oil filter on a 2007 Honda Odyssey is located on the passenger side of the engine block, low in the engine bay, and accessible from underneath the vehicle.
The Odyssey’s 3.5-liter V6 (J35A) uses a spin-on oil filter mounted to the block near the oil pan. It sits low in the engine bay on the passenger side and is typically easiest to reach from below. This guide explains exactly where to look, how to identify it, and how to replace it safely.
Location in the engine bay
To avoid removing components or chasing shadows, look for the filter in a sheltered spot on the lower-right side of the engine when facing the vehicle’s front. It’s a metal canister that screws onto the engine block, often with a visible gasket at the base and a threaded inlet for the oil feed.
Practical steps to locate it
Before you begin the search, make sure the van is on a level surface and the engine is cool. If you’ll be working underneath, use jack stands and wear eye protection.
- Park on level ground and engage the parking brake. If you’re lifting the van, use a floor jack and support with jack stands.
- Crawl underneath from the passenger side and look up at the lower portion of the engine block near the oil pan.
- Identify a cylindrical filter screwed into the block; it will be around the same diameter as a half-dollar and about 2-3 inches tall, with a metal body and a threaded end.
- Confirm you’ve found the filter by tracing the oil lines and nearby components (oil pan, drain plug, and, in some models, a filter mounting bracket).
Conclusion: On the 2007 Odyssey, the oil filter is on the passenger side of the engine block, low in the bay, and accessible from beneath the vehicle.
Notes for replacement and service
Before replacing the filter, ensure you have the correct filter model for the 3.5L V6 and fresh engine oil of the recommended grade. Some trims may use a cartridge-style filter instead of a traditional spin-on canister; if your model uses a cartridge, the filter will be accessed via a removable cap on the side of the engine block rather than a visible canister. When in doubt, refer to the owner’s manual or a service manual for the exact part number and procedure.
In short (emphasis for safety): The filter location is consistent for most 2007 Odyssey models, located on the passenger side low in the engine bay, requiring access from underneath for many DIY oil-change scenarios.
Summary
The oil filter on a 2007 Honda Odyssey is located on the passenger side of the engine block, low in the engine bay, and is generally accessible from beneath the vehicle. This placement is typical for the 3.5L V6 and can be accessed with basic tools during an oil change, using proper safety precautions. When in doubt, consult the service manual or a qualified mechanic for exact removal procedures.