On most Honda CR-V models, the interior fuse box is located on the driver's side under the dash, in the knee area, behind a removable panel. The exact layout can vary by year, so consult the owner's manual or the fuse box lid diagram for your vehicle.
Accessing the interior fuse box
Use these steps to safely locate and access the interior fuse box and replace fuses as needed.
- Park the vehicle, set the parking brake, and turn the ignition off. Remove the key if your model uses a key.
- Open the driver's door to gain clear access to the footwell area.
- Look for a small rectangular panel on the left side of the dash near the knee area (left of the steering column).
- Carefully pry off the panel cover to reveal the fuse box and its diagram.
- Consult the lid diagram to identify the fuse corresponding to the circuit you’re servicing (e.g., interior lights, power windows, or the audio system).
- Remove the blown fuse using the included fuse puller or a pair of needle-nose pliers, then replace it with a fuse of the same amperage rating.
- Reconnect the panel, close the dash cover, and test the circuit.
After replacing a fuse, recheck the function. If the fuse continues to blow, stop using the circuit and seek professional diagnosis to avoid further electrical damage.
Common interior fuses and what they control
Fuses inside the cabin protect a variety of circuits. The exact fuses and amp ratings vary by year and trim, so always refer to the fuse box lid diagram for your vehicle.
- Interior cabin lighting and dashboard instrument illumination
- Power windows and door lock circuits
- Infotainment/radio and speakers
- HVAC blower motor and climate controls
- Sunroof (if equipped) or other auxiliary circuits
- Other convenience electronics mapped on the fuse diagram
Use the diagram on the fuse box lid to locate the correct fuse and replace it with the same amperage. If a fuse keeps blowing, there may be a fault in the circuit that requires professional inspection.
Model-year notes
Generational variations
While the general location described here applies to most current-generation CR-Vs, some older or specialty trims (and hybrids) may have slight differences in fuse box layout. For precise maps and amperage ratings, consult the owner’s manual or Honda’s official service information for your exact year and trim level.
Summary
The interior fuse box on a Honda CR-V is typically found on the driver's side under-dash in the knee area, behind a removable panel. Access it by removing the panel, use the lid diagram to identify fuses, and replace blown fuses with the same amperage. Always verify year-specific guidance in your manual.