Inside the cabin on the driver's side, pull the interior hood-release lever to pop the hood, then go to the front to release the secondary latch and open it fully.
In-cabin hood release location
To locate and use the interior latch, look under the dashboard on the driver's side, near the floor/footwell. The lever is usually labeled with a hood icon and is often a bright color for visibility.
- Reach under the dash on the driver's side and grab the hood-release lever.
- Pull the lever firmly toward you. You should hear or feel the hood pop up slightly.
- Return to the front of the vehicle to access the primary latch.
Using this interior release is the first step to opening the hood; it disengages the primary latch so you can access the secondary latch from the outside.
Front hood latch and full opening
With the interior latch released, approach the front of the CR-V and locate the secondary latch under the center area of the hood, just above the grille.
- Slide your hand under the front edge of the hood to feel the secondary latch.
- Push or lift the latch outward (depending on the model) while lifting the hood slightly.
- The hood is held open by gas struts on the 2007 CR-V, so you won’t need a prop rod; lift it until it stays open.
If the latch doesn’t release smoothly, avoid forcing it; a stuck cable or latch can indicate a maintenance issue that may require inspection.
Additional tips
Always ensure the vehicle is on level ground and the engine is off before attempting to open the hood. Refer to the owner’s manual for model-specific notes or variations.
Summary: The 2007 Honda CR-V uses an interior hood-release lever inside the driver's side footwell to pop the hood, followed by a front-center secondary latch to fully open it. The hood is supported by gas struts, eliminating the need for a prop rod.